Observint BC600 Series User Manual - 2.3 Camera Adjustments
5
High Resolution Indoor/Outdoor IR CCTV Bullet Camera User Manual
SECTION 2: INSTALLATION
NOTE
Position the base plate so that the cable guide in the mounting bracket is pointing away from any source of water,
dust, and other contaminates.
2.
Drill holes for the screws that anchor the base to the mounting surface. The mounting hardware provided is appropriate for
most surfaces. However, depending on the surface materials, more appropriate fasteners may be required.
3.
Drill a 3/4" hole for the drop cable, if necessary.
4.
Route the drop cable through the hole through the base plate, or through the cable guide in the mounting bracket, then
attach the camera assembly to the surface using the appropriate fasteners.
5.
Connect the camera drop cable to video and power extension cables as required.
NOTE
Drop cable connectors are not waterproof.
2.3 Camera adjustments
1.
Apply power to the camera.
2.
If using a CCTV video system monitor to setup your camera, connect the video output of the camera to your CCTV monitor.
3.
Verify that video from the camera can be seen on the monitor.
4.
While observing video from the camera, use the hex wrench provided to loosen the two mounting bracket adjustment
screws.
5.
Point the camera at the center of your surveillance target, then tighten the bracket adjustment screws.