1. DL manuals
  2. Observint
  3. Security Camera
  4. BLK-HDC10
  5. User manual

Observint BLK-HDC10 User manual

Manual is about: 2-Megapixel Full-HD C-mount Box Camera

Summary of BLK-HDC10

  • Page 1

    Blk-hdc10 2-megapixel full-hd c-mount box camera user manual please read this manual before using your camera, and always follow the instructions for safety and proper use. Save this manual for future reference. Blk-hdc10_cm.

  • Page 2

    Ii warning ! Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. Caution to prevent electric shock and risk of fire hazards, use a power source that is within specification only. Do not expose this appliance to rain or moistur...

  • Page 3

    Iii 2 mp full hd c-mount box camera user manual precautions warning - do not install this equipment in a confined space such as a bookcase or similar unit. Warning - wiring methods shall be in accordance with the national electric code, ansi/nfpa 70. Warning - this is a class a product. In a domesti...

  • Page 4

    Iv important safety instructions 1. Read these instructions - all these safety and operating instructions should be read before the product is operated. 2. Keep these instructions - the safety, operating and user instructions should be retained for future reference. 3. Heed all warnings - all warnin...

  • Page 5: Table of Contents

    V 2 mp full hd c-mount box camera user manual table of contents table of contents precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Iii disposal.Of.Your.Old.Appliances. . . . . . . . . ....

  • Page 6

    Vi.

  • Page 7: Section 1

    1 2 mp full hd c-mount box camera user manual section 1: introduction section 1 introduction this high definition indoor c/cs mount camera features 2.1 megapixel imaging with 1920 x 1080 resolution along with 3-dimensional noise reduction (3d-nr). A lens is not included. 3d-nr automatically provides...

  • Page 8: 1.1.1  Camera Back Panel

    2 section 1: introduction notes: • lens: the camera accommodates a standard c or cs mount lens. • menu operation buttons: slide the side panel back to access these buttons. See “3.1 menu operation” on page 8 for more information. • mounting bracket: the mounting bracket can be attached to the top-si...

  • Page 9: 1.2  What You Need

    3 2 mp full hd c-mount box camera user manual section 1: introduction notes: • power indicator - led lights when the power is applied to the camera. • external device connectors: — d&n - to set the d&n (day and night) function manually, connect the external switch to set the d&n terminals. Open the ...

  • Page 10: Section 2

    4 section 2: installation section 2 installation 2.1 camera installation bracket setup the camera can be attached to a mounting bracket on the upper side or the underside of the camera. Normally, the bracket is factory installed on the underside of the camera. If the camera will attach to the mounti...

  • Page 11: 2.2  Attach The Lens

    5 2 mp full hd c-mount box camera user manual section 2: installation 2.2 attach the lens the camera will accommodate a c- or cs-type lens. To attach the lens, do the following: 1. Remove the lens mounting cap from the lens mounting ring as shown below. Lens mounting ring cap 2. Carefully screw the ...

  • Page 12

    6 section 2: installation 4. Follow the manufacturer’s instructions to attach the camera mounting bracket to the mounting surface. 5. Attach the camera to camera mounting bracket. 6. Attach the rs-485, alarm output device, and d&n switch to the terminal block on the back of the camera, as needed. Se...

  • Page 13

    7 2 mp full hd c-mount box camera user manual section 2: installation 9. Connect power leads to the power terminals on the back of the camera in compliance with local codes. Ensure that the leads do not have applied to them when making the connections. Connect the leads in accordance with the termin...

  • Page 14: Section 3

    8 section 3: configuration setup section 3 configuration setup use the on-screen display (osd) menus to configure your camera for the environment where it is installed and recording requirements you prefer. 3.1 menu operation navigation through the menu system is performed menu navigation buttons lo...

  • Page 15: 3.2  Camera Mode

    9 2 mp full hd c-mount box camera user manual section 3: configuration setup 3.2 camera mode camera mode: select mode type: d&n (day and night) / color / ir smart / ir cds. The mode selected affects the content of some displays. 3.3 exposure to open the exposure menu, rock the joystick down (or up) ...

  • Page 16: 3.4  White Balance

    10 section 3: configuration setup color model — auto / day / night / ext — delay: 0 ~ 255 second — burst: off / on — thrs: low / middle / high — gap: low / middle / high ir smart model (not used with this camera) ir cds model — auto / day / night » delay: --- » burst: off / on » thrs: --- » gap: ---...

  • Page 17: 3.5  Image

    11 2 mp full hd c-mount box camera user manual section 3: configuration setup — manual: you can change wb as changing “red gain” and “blue gain” in manual mode. » red gain: adjust r gain value 0 ~ 20 » blue gain: adjust b gain value 0 ~ 20 — indoor: set color temperature to be indoor light (3700 k) ...

  • Page 18: 3.6  Intelligent

    12 section 3: configuration setup • ace: select digital wdr (wide dynamic range): off / on. Note: when ace is on, wdr/blc and defog function can not turn on. Wdr off wdr on • dnr: select digital noise reduction: auto / off / low / middle / high • d.Compress: use this function only with ip camera. Se...

  • Page 19: 3.7  Special Function

    13 2 mp full hd c-mount box camera user manual section 3: configuration setup 3.7 special function • shading det: sets the shading calibration that the lens will perform. Only occurs when the entire screen is viewed in white light.(off / on) • shading: select lens shading compensation. (off / on) • ...

  • Page 20: 3.8  Display

    14 section 3: configuration setup 3.8 display • disp sel: select display item. — id: off / on — title: off / on — ezoom: off / on • set title: select camera title menu (text edit) set title character set (on-screen).

  • Page 21: Section 4

    15 2 mp full hd c-mount box camera user manual section 4: specifications section 4 specifications table 1. Component specifications component value image sensor 1/3" panasonic cmos total pixels 2010 (h) x 1108 (v) = 2,227,080 (pixels) active pixels 1944 (h) x 1092 (v) = 2,122,848 (pixels) scanning s...

  • Page 22

    16 section 4: specifications component value hlc off / on ace off / on dnr off / low / middle / high / auto d.Compress off / on gamma 0.45 – 0.65 intelligence privacy off / on (32 points) special func shading det off / on shading off / on defect det off / on defog off / on system ntsc / pal hd forma...

  • Page 23: Appendix A

    17 2 mp full hd c-mount box camera user manual appendix a: troubleshooting appendix a troubleshooting if you experience problems you cannot resolve, please contact your distributor. Problem solution nothing appears on the screen. - check the power connections. - check the video cable connections. - ...

  • Page 24: Appendix B

    18 appendix b: camera dimensions appendix b camera dimensions 5.45” .41” 2, 15 ” .1” - 1/4” - 20 unc 1.86” .55” 2.78”.