Ocean AM-H12A4/SR1 Installation & Operation Manual - page 7
5
Parts Description
FRONT VIEW
Remote control
REAR VIEW
Circulation Mode
1. Press MODE button in a sequence until the "FAN" display appears..
2. Press the FAN button to select the fan speed.
3. Press the ON/OFF button to start the unit and press it again to stop.
Timer Operation
1. Press the TIMER button .
2. Press the
+
and
-
button to adjust your timer time.
Drying Mode
1. Press the MODE button in a sequence until the "DRY" display appears..
2. The fan will run at a fixed speed at this operation mode.
3. Close windows and doors for the best dehumidifying effect.
4. Press ON/OFF button to start the unit and press it again to stop.
8
Before Starting the Unit
1. Select a suitable location, make sure the unit is near to an electrical outlet.
2. Install the flexible exhaust hose and the adjustable window slider kit.
3. Plug the unit into a right outlet.
4. Plug one end of drain pipe into the water full auto-drain outlet and plug the
other end plug into the windows installation board .
5. Turn the unit on.
Cooling Mode
1.Press the MODE button in a sequence until the "COOL" display appears..
2.Press the + and - button to set your desired set temperature.
3.Press FAN button to select the fan speed.
4.Press ON/OFF button to start the unit and press it again to stop.
Heating Mode
1.Press the MODE button in a sequence until the "HEAT" display appears..
2.Press the + and - button to set your desired set temperature.
3.Press FAN button to select the fan speed.
4.Press ON/OFF button to start the unit and press it again to stop.
Attention: In heat mode ,you need to replace the location of the shutters and
the exhaust pipe, see page 9 "installation" to replace the shutters".
Note:
Time off
is effective only when the air-conditioner is running.
Time on is effective only when the air-conditioner is stopping.
Operation
Failure to follow the below precaution could result in electrical shock,
fire or personal injury.
1.The plug must be plugged into an outlet that is properly installed and
grounded.
2.Do not use an extension cord or plug adaptor with this unit.
WARNING
Handle recess
Handle recess
Control panel
Air outlet
Air outlet
Castors
Front panel
Air inlet
Air inlet
Rear panel
Drain outlet
Signal receiver
windows
Window outlet 1
Window outlet 2
SET
TEM
PERA
TUR()
SET
ON/O
FF
MOD
E
CLE
AN
SPE
ED
SLE
EP
LOCK
HEA
TER
SWIN
G
DUST
SWIN
G 2
HEAL
TH
FUN
GUS
PRO
OF
SCR
EEN
TIMER
AUTO
FAN
COOL
HIGH
DRY
MID
HEAT
LOW