Ocean Breeze OBZ-14PE Owner's Manual - page 16

CARE  AND  MAINTENANCE

CARE AND MAINTENANCE

     1)  Be sure to unplug the unit before cleaning or servicing.

     2)  Do not use gasoline, thinner or other chemicals to clean 

          the unit.

     3)  Do not wash the unit directly under a tap or using a  hose.

          It may cause electrical danger.

     4)  If the power cord is damaged, it should be repaired by 

customer service or the manufacturer.

IMPORTANT:

1.   Air filter

-     Clean the air filter at least once every two weeks to prevent 

   degrading fan operation because of dust. 

-     Removal 

      This unit has two filters.  Grasp the upper filter tab(Fig.25), 

,,

,,

      pull the filter  out  then  up . Remove the lower filter by 

      loosening the screw, taking down the air inlet grille, then

      removing the air filter as shown in Fig.26 & 27.    

-     Cleaning 

      Wash the air filter by immersing it gently in warm water

     with a neutral detergent. Rinse the filter   and dry in a

 shady place. 

-     Mounting 

Reinsert the upper air filter from the top after cleaning, attach

      the lower air filter on the air inlet grille, then install the grille

      by using the screw.

2.   Unit enclosure

-     Use a lint-free cloth soaked in neutral detergent to clean  

      the unit enclosure. Finish with a dry clean cloth.

3.   Unit idle for a long time

,,

,,

-     Remove the rubber plug at the back of the unit and attach

      a hose to drain outlet

. Place the open end of the hose 

      directly over a drain or separate container to dispose of 

later 

(See Fig.22 & 23).

-     Remove  the plug from the bottom drain outlet, all the water 

       in the bottom tray should drain out (See Fig.24). 

-     Keep the appliance running on FAN mode for half a day in 

      a warm room to dry the appliance inside and prevent mold

      forming.

-     Stop the appliance and unplug it, wrapped the cord and 

      bundle it with the tape(Fig.28). Remove the batteries from

      the remote controller.

-     Clean  the air filter and reinstall it.

-     Unscrew the exhaust hose to the right or left and pull out

to detach(Fig.29), keep it safety, and cover the window

(wall) hole with the adaptor cap.

Fig.29

14

Fig.25

Air filter

(slide out)

Fig.26

Fig.28

Remove three

screws and 

take the air

intake grille 

down 

Remove the air filter 

out from the grille

Fig.27

Band

Power 

cord