Ocean E2882S Operating Instructions Manual - page 7
1.使用中發現異常狀況時,請將
關閉或拔掉插頭,並洽請代理商服務部到府上
維修。
2.處理異常狀況時,請先拔掉插頭。
電源
狀況
電源線損
壞
燈亮
馬達不轉
底板
外源漏油
機體震動
吸力不強
機體裝設
歪斜
原因及處置方法
Ù請 就 近 洽 本 公 司 服 務 站 或 經 銷 商 到 府 上 維 修 。
Ù電 源 線 規 格 :
H05W-F(227E IEC53)3GO.75mm2300/500V
A.拆下立體濾油網(保護網),用手轉動風葉,如轉不
動,查看風葉是否卡住。若是,請調整風葉。
B.如風葉用手輕動皆能運轉自如,則是電容器的問
題:
1.先看啟動線(黃色電線)是否脫離電容器(參考配
線圖)。
2.啟動線沒脫落,就是電容器損壞,必須換電容
器。
C.如按下馬達按鈕,馬達稍運轉即停止,而於馬達處
可聞到一股燒焦臭味,則馬達燒毀,必須更換馬
達。
A.拆下立體濾油網(保護網),查看兩入風口墊圈與排
風室是否密接妥當。
B.拆下底板,查看排風室外緣與頂板之結合處是否漏
油;若是,即用玻璃膠予以補填。
A.查看馬達是否鎖緊。
B.如馬達已鎖緊,則是風葉受損,不平穩轉動時會產
生震動,應更換風葉。
A.如發現左右歪斜則由吊鐵調整左右高度。
B.如發現向前傾斜,則由木螺釘再行鎖入牆壁,(釘
身大約0 .5- 1公分於壁外),或查看吊鐵固定於機體
的螺絲是否鬆落。
使用工具
十字起子
尖嘴鉗
1 /4 "板手
十字起子
十字起子
1 /4 "板手
十字起子
十字起子
A.抽油煙機與爐面的距離太高。
B.抽油煙機周圍環境門窗通風多,對流太大。
C.抽油煙機裝置在窗戶前。
D.參考安裝原則及安裝注意事項進行安裝。
1. Operation:
4. Cleaning:
Press on the button for the operation
Take out two oil drawers.
desired as follows:
‧Loosen the screws on both front
corners of the bottom cover plate and
pull it down afterwards.
‧Disassemble the oil disc, loosen the
screw cap and pull the fan down for
cleaning.
‧Use soft cloth to clean the inner and
outer surface with soft liquid detergent
and then rinse with water. Avoid using a
2. Assembling and disassembling of round
stiff brush, e.g. metal brush may scrub
oil collector:
the surface;
‧Empty dir ty oil collectors when they are
‧After cleaning, assemble the par ts in
4/5 full and clean the collectors
with
reverse procedures as above shown.
detergent before put them back in situ.
Ù Make sure that the lower bottom cover
‧To empty and clean the round oil
is securely hooked with the hood body.
collector, turn it counterclockwise to
take it down and the vice versa to put it
back after emptying and cleaning.
‧To empty and clean the oil drawer, pull
it out and put it back afterwards.
3. Each range hood comes with 20 pcs. of
disposable oil cups. For replenishment,
please contact our ser vice depar tment.
FAN
HI-LOW SPEED
ILLUMINATION ON / OFF OF LIGHT
POWER
ON / OFF OF POWER
FAN
HI-LOW SPEED