OceanAudio Signature Three Owner's Manual

Summary of Signature Three

  • Page 1

    Signature three owner’s manual www.Oceanaudio.Co.Uk.

  • Page 2: Contents

    Signature three - owner’s manual - revision 1 - page 2 contents about the designer 3 product description 4 connecting the unit 5 operation 6 trouble shooting 7 technical specifications / warranty card 8 malcolm toft signature series range 9.

  • Page 3: About The Designer

    Signature three - owner’s manual - revision 1 - page 3 malcolm toft started his career in the late 60’s as a recording engineer and was the first engineer to be employed at the famous trident recording studios in london. Among his credits are the recording of david bowie’s ‘space oddity’ album, jame...

  • Page 4: Product Description

    Signature three - owner’s manual - revision 1 - page 4 product description the signature three equaliser consists of two identical channels of discrete transistor - inductor based equalisation. Silicon transistors as opposed to integrated circuits (op-amps) provide a much simpler dedicated signal pa...

  • Page 5

    Signature three - owner’s manual - revision 1 - page 5 connecting the signature three the rear panel of the unit provides both xlr and ¼” jack inputs for the input and output of each channel. All inputs and outputs are balanced and use the standard industry convention : xlr connectors pin 1 : ground...

  • Page 6

    Signature three - owner’s manual - revision 1 - page 6 operating the signature three to use either equaliser channel, first make sure that all of the boost and cut controls (top row of knobs) are in their mid or flat positions. You should feel a small click at the mid position which denotes the 'fla...

  • Page 7: Trouble Shooting

    Signature three - owner’s manual - revision 1 - page 7 trouble shooting 1) no power. Make sure the unit is connected to a suitable ac outlet providing between 80 and 260 volts. Check that the fuse (situated in the mains inlet socket) is the correct rating and that it has not failed. Make sure the il...

  • Page 8: Technical Specifications

    Signature three - owner’s manual - revision 1 - page 8 technical specifications input impedance (jack and xlr) : >15k ohm electronically balanced output impedance (jack and xlr) : frequency response : ± 1db 15hz to 35khz maximum output level : >+28dbu at all frequencies eq in or out dynamic range : ...

  • Page 9

    Signature three - owner’s manual - revision 1 - page 9 malcolm toft signature range signature two dual channel classic fet compressor with variable mix control for parallel compression signature one channel strip with : • mic / line preamp with custom transformer • mic gain range from -10 db to 60 d...