Oceanic Data Mask Operating Manual - page 77
77
CONTROL OF DISPLAYS
During Dive Modes, there is a Main (Default) Display of important information relevant to
the specific mode that the DataMask is operating in (No Deco, Deco, GAU, FRE, etc.).
Alternate (ALT) Displays can be accessed by pressing and releasing the A (Top) button to
view additional information. They will automatically revert to the Main Display after 5
seconds unless the A (Top) button is pressed again to view another Alternate Display.
DIVE MAIN > ALT 1 > ALT 2 (only if Nitrox) > ALT 3
Alarms can be acknowledged/silenced by pressing the A (Top) button for 2 seconds.
The S (Side) button is used to toggle the Backlight On/Off.
When Alarms strike, the Backlight will come On if set Off and remain On until the
Alarm condition clears.
The Backlight will not activate during a Low Battery condition.
WET CONTACTS
The Wet Contact Dive Mode Activation feature is active when it is set ON. The DataMask
is configured with contacts that will automatically activate Dive Mode when the space
between the contacts is bridged by a conductive material (immersed in water) and it
senses a Depth of 5 FT (1.5 M) for 5 seconds.
When the Wet Activation feature is set OFF, the DataMask will not enter Dive Mode upon
descent unless it is first Activated by push button and operating in one of the Dive Com-
puter modes (menus) at that time, a mode such as Surface, Fly, Log, etc.