OCOSMO CB301523 Manual - Fcc Compliance Statement

- 23 - 

Sound Bar 2.1 User Manual 

FCC Compliance Statement 

This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following conditions: 

This device may not cause harmful interference 

This device must accept any interference received, including interference that my cause undesired 

operation. 

Please Note: This equipment has been tested and found to comply with the limits for a Class B 

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates uses 

and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of the 

following measures: 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and the receiver. 

Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected. 

Caution: To comply with the limits for an FCC Class B computing device, always use the 

signal cord and power cord supplied with this unit. 

The Federal communications Commission warns that changes or modifications to the unit not 

expressly approved by the party responsible for compliance could void the user’s authority to 

operate the equipment. 

European Notice 

Products with the CE marking comply with both the EMC Directive (89/336/EEC), (93/68/EEC) and 

the Low Voltage Directive (72/23/EEC) issued by the Commission of the European Community.