Octave V 50 MKII Owner's Manual - page 18
11. TECHNICAL DATA
Features
1. Electronic protection- and controlling-system: The V 50 is equipped with a current at make-
limitation. This protects the tubes against peak loads that occur, when the V 50 is turned on.
Heating and operating voltage are adjusted slowly to operating standards. The life of the tubes
is thereby prolonged tremendously. At the same time, the electronic protection controls the
power amplifier. In case of overmodulation, short circuit of the loudspeaker outputs or tube
damages, the power amplifier is turned-off. The loudspeakers and the electronic of the power
amplifier are therefore fail-safe.
2. Stand-by function of the power amplifier to bridge middle periods of not being used (max. 5
hours). Also important to burn in new tubes
3. Auto-bias electronic:The electronic adjusts automatically to the tubes used. Tolerances of the
tubes, due to age or supply fluctuations, are fully stabilized. This makes it possible to use vir-
tually every tube available on the market, without having to adjust it.
4. A newly developed 600 VA-power-transformer
5. New developed, completely low-noise phono and line stages
6. By connecting the optional black box as an external boost of the power supply, the power and
the dynamic of the power amplifier can be increased once again.
7. The front panel is mill-cutted of massive aluminium and can be produced on demand in spe-
cial anodised colours.
Technical data
Power amplifier section:
power output:
2 x 50 Watt, 4 Ohms
frequency response:
10 Hz - 50 kHz / 0 - 3 dB
distortion factor:
<
0,1 % with 5 Watt, 8 Ohms
signal to noise ratio:
>
90 dB
attenuation factor:
8
minimal load impedance:
2 Ohms
Phono section:
sensibility MC:
0,1 mV
input resistance
100 Ohms
sensibility MM
4 mV
input resistance MM
47 kOhms II 150 pF
General data:
power consumption:
100 Watt no-load operation, 250 Watt full modulation
50 Watt in stand-by mode
dimensions:
380x170x440 mm (width x height x depth)
weight: 23
kg
remote control for the volume
infrared transmitter with 2 x 1,5 V, size AA
Notice: The information contained in the manual is subject to change without notice
17