OCZ MOD X STREAM-PRO User Manual - Installation

Installation

To prevent electrical shocks, please disconnect the power  

cord from your existing PSU.

Make sure the I/O switch of the new PSU is at the off  “O” 

position.  After installing the new PSU into the chassis, 

connect the Main power connector to the mother board. 

Note:  Please refer to your motherboard user guide to reference the 

connection requirements of the Main power connector and CPU 

connector of your particular components.

Connect the CPU connector to the CPU socket on the 

 mother 

board.

Connect the PCI-E connector to the graphic card if needed.

Connect the peripheral connector to peripheral devices such 

as DVD, HDD, etc.

Connect the Floppy disk connector to the floppy drive if any.

Connect the S-ATA connector to the S-ATA HDD if any.

For a PSU with cable management (modular), connect the 

other side of the cable to the corresponding connections on 

 the 

PSU.

Make sure all connectors are firmly connected.

 Protection 

function

To safe guard the power supply and your system, this ModXStream 

PSU includes comprehensive protection functions;  Over Voltage 

Protection, Under Voltage Protection, Over Power Protection, 

Short Circuit Protection,  Over Temperature Protection.

Note:  If the PSU goes into shut down status, the PSU will return to 

normal operation only after the fault has been removed and the 

power switch has been cycled off/on for a minimum of 1 second;  

or you may re-plug in the AC power from the PSU.