Ocznbia10a installation guide.
Neutrino installation guide 01 carefully remove the neutrino netbook from the bag and sleeve and inspect it for damage. The top panel of the neutrino netbook is protected by an adhesive clear plastic sheet. Please do not remove this until you are finished with the complete hardware installation to a...
Preparing / replacing the hard disk drive 02 the ocz neutrino netbook uses a serial ata interface, therefore, any 2.5” mobile hdd/ssd selected for this system needs to comply with the sata standard. The hdd drive bay is located underneath the access panel. Carefully remove the two remaining screws m...
03 pull the black tab in the direction of the arrow to disengage the sliding retention bars from the rail as shown below and remove the drive bay from the netbook. Fasten the four screws onto the harddrive and bracket..
04 install the drive using the appropriate screws and re-insert the drive bay with the drive into the netbook. Please ensure that the sliding retention bars engage with the rails and pull the assembly in the direction of the large arrow until it aligns with the screw holes. Secure the drive bay usin...
05 position the memory module in the slot and slightly tap it to ensure full insertion. Then gently press the module down until it lies flat and engages with the retention clips as shown in the picture below. Installing memory.
06 close the cover and secure it with the appropriate screws. Reinstall the battery if necessary..
For support and technical information, please visit www.Ocztechnology.Com copyright © ocz technology group 2009. All rights reserved technical support for warranty support and technical information about your diy notebook, visit www.Ocztechnology.Com. All ocz products include free technical support ...
