OCZ Z-Drive R4 Installation & Quick Start Manual - Under Linux

- 21 -

Update Z-Drive R4 in Windows

Update Windows Driver

1.  Follow “Download the Latest Driver (Optional)” section to download the latest driver.

2.  Double click on setup.exe to install the new updated driver.  Follow the instructions on the screen

Update Firmware in Windows

1.  Please refer to the Firmware Update Guide for Windows to update Z-Drive R4 Firmware.

Under Linux 

Installing the Linux Driver to Use the Z-Drive R4 as a Storage Drive

The Z-Drive R4 can be used as a storage device in a computer with an existing Linux installation.

1.  Follow the “Hardware Installation” section to install the Z-Drive into the computer.

2.  Turn on the computer and boot Linux.

3.  Insert the enclosed Driver CD or the CD/USB key prepared in the “Download the Latest Driver 

  (Optional)” section into the computer CD drive or USB slot.

4.  Copy ocz10XX.ko in the Linux folder to a location on the Linux host.

5.  Open a terminal with root privileges.

6.  Go to the location where ocz10XX.ko was copied to.

7.  Load the driver by typing “insmod ocz10XX.ko” (See Figure 19).

8.  The driver is installed when the cursor on the terminal returns.

9.  Follow the “Formatting Z-Drive R4 in Linux” section to start using the Z-Drive R4.

NOTE: OCZ Toolbox must run in “administrator” mode.

Figure 19: Load Driver in Linux with insmod Command