Odyssey Stellar NX Instruction & Reference Manual - Notice

CHARGING THE Stellar NX DRONE

RADIO CONTOL TRANSMITTER • BATTERY INSTALLATION

If the Radio Control Transmitter will not be used for extended periods of time, please remove the batteries.

Please use 3 AA batteries. Use the polarity markings to install in the 

correct orientation. Do not mix batteries of different types.

Unscrew the screw holding the battery lid to the 

body. Then lightly pull the clip down to pull the lid 

away from the transmitter body.

Insert 3 x AA batteries into the battery compartment, 

making sure to match the polarities. Then replace the 

lid and firmly tighten the screw to secure the battery 

compartment. 

NOTICE

NOTICE

The Stellar NX battery comes partially charged and is ready to fly. 

Refer to Remote Control Battery Installation section and use your 

Stellar NX now. Use this charge completely before charging the Stellar 

NX battery for the first time. 

WE RECOMMEND!

At the rear of the drone, pull the upper and lower battery clips away from unit. Slide out the battery.

Connect the USB charging cable and the battery.

Insert the USB connection of the charging cable into a powered USB computer port. Please note: 

Not all USB ports provide power. Typically, only ports directly on a computer, and not through a 

peripheral, will provide enough power for charging.

A complete charge will take approximately one hour. The LED on the battery will turn off when 

charging is complete.

When the battery is fully charged, immediately disconnect the charging cable from the battery and 

reinstall the battery into the Stellar NX drone.

1.

2.

3.

4.

5.

When charging with the included USB cable, the LED light will light 

up red, indicating it is charging. Once charging is complete, the LED 

light will turn off. Discontinue charging immediately.

Please check the AA batteries routinely. If the AA batteries are left within the Radio Control Transmitter, 

potential leakage and/or corrosion may occur, which can damage the transmitter and create a fire hazard.

CAUTION

WARNING

Rechargeable Lithium 

Polymer Battery

3.7V / 700 mAh

At the rear of the 

drone, pull the upper 

and lower battery 

clips away from unit. 

Slide out the battery.