Odyssey TURBO RUNNER Manual - page 4
ASCEND/
DESCEND
LEFT/
RIGHT
FORWARD/
BACKWARD
MOTION &
STRAFING
Push the left joystick
(throttle) up to ascend. Ease
the throttle (left stick)
downwards in order to make
the Turbo Runner go lower in
altitude.
To TURN LEFT or RIGHT:
Push the left joystick to
the left to turn left or
right to turn right.
To GO FORWARD & BACKWARD
Push the right joystick up to
make the quadcopter fly
forward. Push it down to make
the quadcopter fly backward.
To STRAFE LEFT & RIGHT:
Push the right joystick to the left
to make the unit go sideways to
the left without turning (this is
called strafing). Push the right
joystick to the right to make the
unit go sideways to the right
without turning.
NOTE: Strafing is
useful when you
want to make the
unit go side to side or
go around obstacles
where it might be
difficult to turn or
rotate the unit.
Connect the battery on the unit. Then lay the unit flat on the ground
and you will see the two LEDs flashing red on the Turbo Runner
Fuselage Cover.
Power on the Radio Control Transmitter. Push the left joystick all
the way to the top and then again back down to begin pairing. If
paired successfully, the transmitter will make a beep sound and the
LEDs on the unit will stop flashing. You are now in flight mode.
TO RESET THE UNIT
1. Lay the unit flat on a level surface or the ground.
2. Push both the left and the right joystick to the bottom right
corner position until the LEDs on the unit begin to flash.
3. The RESET is complete when the LEDs on the unit
stop flashing.
Please note, when resetting the unit using the controller, the quadcopter
must be completely still and its main body must be horizontally leveled.
GOING TO FLIGHT SCHOOL • CONTROLLING THE TURBO RUNNER QUADCOPTER UNIT
PREPARING YOUR UNIT TO FLY • PAIRING YOUR REMOTE / RESETTING YOUR UNIT