Odyssey XV-7 Microlite II Instruction Manual - Notice
FLYING SAFE • BE AWARE OF YOUR ENVIRONMENT and SURROUNDINGS
TECHNICAL SPECFICATIONS & PARAMETERS
CAUTIONS & WARNINGS
If flying outdoors, always fly on a sunny, bright day with as
little wind as possible. Flying in extreme heat or cold can
adversely affect your flying control and response of the
vehicle.
After connecting the battery, lay the XV-7 Microlite II on the
ground. Please wait for approximately 5-7 seconds to allow
the digital gyro to electronically stabilize. Push the throttle
up and then back down to pair the radio control
transmitter to the XV-7 Microlite II. The lights will stop
blinking and now you are all set to fly.
Charging Time: Approximately 90 minutes
Flying Time: Approximately above 6-9 minutes
Radio Control monitor viewing distance limit: approx. 75-100 meters
• Suitable for ages 14 and up. Adult supervision is always recommended.
• This product contains small parts which are a choking hazard. Keep away from small children.
• Keep Quadcopter at least 10 feet away during use.
• Accurately assemble the quadcopter and fly it under the guidelines of this manual. Small parts should be installed by an
adult.
• Manufacturers and dealers disclaim all responsibility for damage caused by misuse.
• Keep hands, hair and loose clothing away from rotors when powered on to to prevent damage to the vehicle or serious injury
to oneself or others around.
• The quadcopter should never be flown in high winds in excess of 5 MPH or near a pool.
• Never leave the device unattended when being charged.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
PREPARING YOUR UNIT BEFORE FLYING
The throttle stick (left stick on the radio control) must be pointing down before the unit and the control are switched on.
Move the ON/OFF switch to the ON position and the Power LED on the radio control will begin to blink.
Connect the battery cable to the power connector on the vehicle. The LEDs on the vehicle will now begin to blink. Place the
quadcopter on the ground with the tail pointed towards you (the two red propellers are the rear of the vehicle). The
quadcopter needs approximately 5 to 7 seconds to initialize and electronically stabilize the gyro. It will also pair with the
radio control transmitter at this time. When the LEDs on the vehicle stay green without blinking, the pairing of the radio
control and the quadcopter has been established.
Be sure to place the quadcopter on a level surface to ensure a proper and neutral alignment of the gyro.