OEM DC BWA-SS-12 Installation And Maintenance Instructions Manual - Commissioning and Adjusting
19
Commissioning and adjusting
Air is initially released from the hot water and venting
may be necessary. If bubbling sounds can be heard
from the heat pump, the entire system requires further
venting. When the system has stabilised (correct
pressure and all the air removed) the heating controls
can be set at the required values.
Check the fluid level in the level vessel (85). If the lev-
el has dropped, close the valve under the vessel. You
can then fill through the connection at the top of the
vessel. After filling, open the valve again.
To raise the pressure, close the valve on the incoming
main pipe when the brine pump (KBP) is running and
the level vessel (NK) is open, so that water is drawn in
from the vessel.
The siphon principle is used to empty the water
heater. This can be done either via the drain valve on
the incoming cold water pipe or by inserting a hose
into the cold water connection.
Readjusting, collector side
Emptying the water heater
Readjusting, heat medium side
1). Read the brine temperatures on the panel. The dif-
ference between these two temperatures should
be 2—5 °C when the system has come into bal-
ance. Adjust the flow with the knob on the brine
pump (32). A high difference indicates a low brine
flow. A low difference indicates a high brine flow.
The pump is
adjustable to adjust
brine flow.
The pump is
adjustable to adjust
heat medium flow.
2). Check the flow temperature and the return
return temperature on the panel. The difference
between these two temperatures, with floating
condensing, should be 5 — 10 °C when the house
is being heated without additional heat. Adjust the
flow with the knob on the heating medium pump
(37). A high difference could depend on a low heat
medium flow. A low difference indicates a high
heat medium flow.
Inspection
NOTE!
7KHFRPSUHVVRUPXVWQRWEHIRUFHGWR
VWDUWZLWKSHULRGVVKRUWHUWKDWVWDUW
SHUPLQXWHV
2/3