1. DL manuals
  2. Oertzen
  3. Swimming Pool Vacuum
  4. 311 C
  5. Operation Manual

Oertzen 311 C Operation Manual

Manual is about: High pressure cleaner

Summary of 311 C

  • Page 1

    Operation manual 311 c 316 c von oertzen gmbh • ferdinand-harten-str. 10 • 22949 ammersbek • tel. +49 40 604110 • fax +49 40 6041149 www.Oertzen-gmbh.De • info@oertzen-gmbh.De 11/08.

  • Page 2

    2 table of content 1. Introduction page 3 2. Safety instructions page 4 - 5 3. Design/configuration/illustration page 6 - 7 4. Start-up/shut-down page 8 - 11 5. Maintenance & care page 12 - 13 6. Electric wiring diagram page 14 7. Technical data page 14 8. Trouble shooting page 15 9. Declaration of ...

  • Page 3

    3 1. Introduction by buying this oertzen high pressure cleaner, you have obtained a most capable machine suitable to perfectly meet your cleaning tasks. All oertzen machines and accessories conform to the national and european safety regulations. The ce label guarantees for fulfilment of all relevan...

  • Page 4

    4 2. Safety instructions the following instructions to be followed before, during and after work: this operation manual to be read before start-up. When strictly following the instructions, no danger should occur. This machine must only be operated by qualified persons who are fully familiar with th...

  • Page 5

    5 consumables to be handled thoroughly. Technical safety regulations and environmental rules to be followed. Make sure that power cable, plug connections switches are in proper condition, otherwise the machine must not be started. Extension cables to have a diameter according to vde regulations. Ext...

  • Page 6

    6 3. Design/configuration/illustration the cold water cleaners of this series mainly comprise a low speed high pressure inline plunger pump which is directly flanged to and driven by a high performance electric motor. The feed water is directed via a filter to the high pressure pump which, together ...

  • Page 7

    7.

  • Page 8

    8 4. Start-up/shut-down before start-up read operation manual and follow instructions. In order to guarantee proper condition of the machine and trouble-free operation, carry out the following checks before start-up: • general condition of the unit (connections, seals, etc.) • power cables/connectio...

  • Page 9

    9 electric connection connect the unit to a power source which is protected according to table below. 311 c 316 c power supply 230 volt 400 volt protection 16 a (slow) 3 x 16 a (slow) extension cables to have a diameter according to vde regulations. Extension cables on reels to be reeled off complet...

  • Page 10

    10 pressure adjustment the working pressure can be continuously be adjusted by opening/closing the handle at the double lance. Counter-clockwise: pressure decrease clockwise: pressure increase detergent dosing only detergents approved by oertzen to be used. Use of hazardous detergents or detergents ...

  • Page 11

    11 after completion of work the unit to be switched off by means of the on/off switch (2). De-pressurise the spray pistol by shortly opening and closing and lock it then. Disconnect the unit from the water and power sources. Reel off high pressure hose and thoroughly clean it. In case of damage repl...

  • Page 12

    12 5. Maintenance and care every machine is only as reliable as maintenance is carried out. According to safety regulations the high pressure cleaner to pass an annual test in order to guarantee safe operation. Test results to be recorded and made available to authorities on their request. Moreover,...

  • Page 13

    13 strainer a strainer (6) is installed at the water inlet of the machine which must be checked and cleaned, respectively replaced whenever needed. Severe damage on pump set and control units can be caused by running the machine with polluted feed water and/or clogged strainer. Frost protection fros...

  • Page 14

    14 7. Technical data technical data 311 c 316 c flow rate/adjustable 600 l/h 780 l/h unloading pressure 160 bar 200 bar max. Working pressure 140 bar 180 bar max. Recoil 28 n 49 n max. Water temperature 50 °c 50 °c electric current 1~230 v/50 hz 3~400 v/50 hz fuse (slow) 16 a 3 x 16 a power consumpt...

  • Page 15

    15 8. Trouble shooting electrical energy can cause severe injuries. Electrical components tho- roughly and frequently to be checked for damages and malfunctions, in order to avoid any cause for accidents. Disconnect the unit from the electrical network during all repair/maintenance work (zh 1/95). T...

  • Page 16

    16.