To be read completely before initial start-up! Operating manual e 500-17 von oertzen gmbh • ferdinand-harten-str. 10 • 22949 ammersbek • tel. +49 40 604110 • fax +49 40 6041149 www.Oertzen-gmbh.De • info@oertzen-gmbh.De 9/08.
2 table of content 1. Introduction page 3 2. Safety instructions page 4 – 5 3. Design/configuration/illustrations page 6 – 7 4. Start-up/shut-down operation page 8 – 10 5. Maintenance and care page 11 – 12 6. Electric wiring diagram page 13 7. Technical data page 13 8. Trouble shooting page 14 9. De...
3 1. Introduction with your oertzen high pressure cleaner you have purchased one of the most durable and reliable machines available on the market. Its balanced ratio of water flow (temperature) and working pressure perfectly meets all cleaning requirements. The oertzen high pressure cleaners confor...
4 2. Safety instructions the following instructions to be followed before, during and after work: this instruction manual to be read completely before initial start-up. If strictly followed, no dangers should occur. This machine must only be run by qualified adult persons who are fully familiar with...
5 electric power can cause severe injuries. All symptoms of faulty electric components to be taken seriously and possible causes for accidents to be eliminated immediately. All repair work only to be carried out by qualified service personnel. Secure the machine against moving. It is equipped with a...
6 3. Design/fuction/illustrations the cold water high pressure cleaners of this series mainly comprise a low speed high pressure inline plunger pump which is directly flanged to an high efficient, 100 % duty cycle electric motor. The feed water is directed with the necessary admission pressure via a...
7.
8 4. Start-up / shut-down before start-up: read and observe operation manual. In order to guarantee proper function and trouble-free operation, the following checks to be carried out before start-up: • general condition of the unit (connections, gaskets, etc.). • power cables/connections. • high pre...
9 power supply insert plug into a 440 v socket which is protected by 3 x 63 a (slow). Only extension cables designed according to vde to be used. Extension cables on reels to be reeled off during operation in order to avoid overheating of the reel. Plug, couplings to be watertight. A faulty current ...
10 high pressure pipe cleaning (option) during pipe cleaning aerosols may be generated, a protecting mask to be worn. Push pipe cleaning hose with nozzle to be pushed into the pipe until the mark (approx. 50 cm) is reached. Open stop valve and start high pressure cleaner by means of the on/off switc...
11 5. Maintenance and care every machine is only as reliable as maintenance is carried out. The machine to pass an annual safety check. Test results to be recorded and to be made available on request. Moreover the following maintenance work to be carried out in regular intervals order to guarantee f...
12 micro filter a micro filter (5) is arranged at the water inlet, the insert of which must be checked before start-up and replaced whenever necessary. If the machine is operated with polluted water or dirty filter inserts heavy damage on the pump set and/or control elements will be the result. Fros...
13 6. Electric wiring diagram 7. Technische daten 7. Technical data technical data e 500-17 water flow 1020 l/h unloading pressure 550 bar working pressure 500 bar normal current (60 hz) 3 ~ 440 v power consumption 18 kw amperage 27 a sound pressure level/sound power level acc. To din en iso 3744 69...
14 8. Trouble shooting electric power can cause severe injuries. All symptoms of faulty electric components to be taken seriously and possible causes for accidents to be eliminated immediately. All repair work only to be carried out by qualified service personnel. During maintenance/repair work, dis...
15.
