OfficeMaster CMS 108 User Manual - page 10
8
Activate Clerk System
• Set the Control Switch to PRG. Type in on the ten-keypad.
• Enter
= Clerk system
active
or
= Clerk system
inactive
• Press the button to confirm.
• Set the Control Switch to PRG. Type in on the ten-keypad.
• Enter
= allow the clerk number only, to begin a transaction.
= allow clerk number & 3-digit security code, to begin a transaction
• Press the button to confirm.
• Set the Control Switch to PRG. Type in
on the ten-keypad.
• Press the button. Then enter the number of the clerk e.g.. (1-8 clerk numbers are available)
• Type in the 3-digit security code. Press the button. Then press the key to finalize.
To activate the clerk system.
4
4
4
4
4
0
1
TOTAL
Activate Clerk Security Code
To activate the 3-digit security code.
1
1
0
1
RA
Preset Clerk Security Code
To preset a 3-digit security code for individual clerks.
4
4
4
4
4
4
TOTAL
CLERK
C
Setting Date & Time
• Set the Control Switch to PRG. Enter date (ddmmyy) e.g.. 211205. Press the button.
• Set the Control Switch to PRG. Enter time (military std) e.g.. 1:00pm = 1300. Press the key.
To programme the date.
ST/#/NS
To programme the time.
QTY/TIME
• Set the Control Switch to PRG. Press the number key.
• Now enter the desired decimal place
= X.
= X.X
= X.XX
= X.XXX
• Press the key to confirm setting.
1
Currency Decimal Point
To programme the decimal point to your currency.
RA
0
1
2
3
CMS-108
Electronic Cash Register
USER GUIDE:
PROGRAMMING
OFF
R1
R2
X
Z
PRG
Slid
e
All programming
is performed
with the Control
Switch in the
PRG position.