Officezone EB-19 Instruction Manual - Eb-19
3
EB-19
Operation Manual and Warranty Registration
Specifications
Machine Dimensions:
18” W x 6” D x 5-1/2” H
Recommended Punching Capacity:
12 sheets per punch (standard copy paper). Punching
capacity may vary with different materials
Sheet size range:
1” to 11” size sheets
Punch Hole Capacity:
19 progressive radius cut dies
Binding Capacity:
Up to 5/8” thick (approx. 120 sheets)
Up to 1 / 2” thick (approx. 90 sheets)
Installation and Setup:
Carefully unpack and inspect your new plastic and wire binding machine for shipping
damage. If any damage is noticed it should be brought to the immediate attention of the
delivery carrier.
The following instruction will demonstrate certain methods and techniques to improve
your binding results. Before using the machine carefully read through these instructions.
This machine is designed to punch up to 12 sheets of common photocopier paper. Cover
materials vary in thickness and composition; as a rule, covers should be punched two at a
time separate from the document. Some brands of clear plastic covers and sheet
protectors do not punch cleanly and may jam the machine. All IBICO cover materials are
manufactured to punch cleanly in an IBICO machine.
Punching:
1) For proper punching alignment, the side guide should be set to the right position for 8-1/2” x 11”
paper and to left position for oversized covers.
2) Raise the handle to the most upright position. Place up to 12 sheets of paper into the punch
opening; marked with rectangles, flush to the side guide and back.
3) For punching ease, always grip the handle at the radius; press down to punch through the paper.
Lift the handle upward to release and remove the paper.
Note: The waste drawer is located on the left side of the machine. It is recommended that it be
emptied regularly.
Binding Plastic:
1) Choose a plastic comb (up to 5/8”). Comb diameter should be 1/8” larger than the document
thickness.
2) Open the binding panel. Position the plastic comb behind the vertical binding fingers.
3) Allow the binding element to drop down between the vertical fingers. Push the elements to the
right until the hooks of the binding fingers are inside the rings of the binding element.
4) Open the binding element by raising the binding handle in a counter clockwise direction. Place
covers and paper on the binding element (front side down) and close the element by rotating the
binding handle in the opposite direction.