1 1-800-543-545 4 ( 801) 927-3026 ideal cutters model 4810 (18-3/4”) model 4810-11 (18-3/4”) model 5210 (20-1/2”) office zone 1-800-543-5454.
2 safety rules • ensure that at no time more than one person is working at the machine. • leave the key for the safety lock with the person responsible for the cutting machine. • power operated cutting machines must be operated only by trained and reliable personnel. Part of the training is to becom...
3 performance all paper qualities and light cardboard can be cut using the full cutting height and cutting length of the machine. 4810 4810-11 5210 cutting length 475 mm (18-3/4”) 520 mm (20-1/2”) cutting height 80 mm (3-1/8”) 80 mm (3-1/8”) table depth 460 mm (18-1/8”) 520 mm (20-1/2”) narrow cut 3...
4 by turning the wheel clockwise: the clamp is lowered. By turning the wheel counter clockwise: the clamp is raised. The paper is clamped by tightening the hand wheel (#19) with a quick pull to the right. Important – only by clamping the paper pile securely is precise cut guaranteed. • back gauge (#...
5 if the motor should be subjected to excessive strain (e.G. Continuous cutting of strong cardboard with a dull knife), the power supply to the motor will be interrupted by the thermal overload switch (#10). The overload button will pop out a few mm. After a short cooling down period, the overload b...
6 10. Screw in knife screws (a and c) – snuggly, don’t tighten. 11. Remove knife holders. Screw in knife screws (b and d) – snuggly, don’t tighten. 12. Spread one to three sheets of paper across the entire cutting length. Bring the knife (#17) down. Release only one push button (#5) and turn main sw...
7 changing of cutting stick should the bottom sheet of a paper pile not be cut across its full length, the cutting stick (#2) must be turned, rotated or exchanged. Important – if the knife has been lowered by means of the cutting depth adjustment screw (#6) to compensate for a worn cutting stick, th...
8 wiring diagram a wiring diagram for the machine is included in the electric switch box, which can be reached by removing the front table (#13). Troubleshooting should the machine cut out during operation, check the thermal overload switch (#10). If the button of the thermal overload switch has pop...
