Catapult 1000 series tm instruction manual.
En-1 catapult 1000 series scales 1. Introduction this manual contains installation, operation and maintenance instructions for the catapult 1000 series scales. Please read the manual completely before using the scale. Tm 1.1 safety precautions please follow these safety precautions: • verify that th...
En-2 catapult 1000 series scales table 1-1. Control functions. Button primary function (short press) on/zero turns scale on. If scale is on: sets zero. Simulates a tare operation. Units changes the weighing unit. Enters dynamic weighing mode. Initiates countdown in dynamic weighing mode. Secondary f...
En-3 catapult 1000 series scales 2. Installation 2.1 package contents • scale • power adapter • instruction manual • warranty card 2.2 location use the scale on a firm, steady surface. Avoid locations with excessive air current, vibrations, heat sources, or rapid temperature changes. 2.3 power 2.3.1...
En-4 catapult 1000 series scales 2.3.2 battery installation (optional) open the battery cover on the bottom of the scale and install three “c” size (lr14) alkaline or rechargeable batteries into the compartment. Orient the batteries as shown on the inside of the compartment. Close the battery cover....
En-5 catapult 1000 series scales net weight. When removing both the sample and container from the scale, a negative value may be displayed. Zero the scale again before subsequent usage. Note: the on/zero off button will perform a true zero setting function when displayed values are within +2% of ful...
En-6 catapult 1000 series scales 4. Calibration for best results, calibrate the scale at regular intervals. (calibration weights are not supplied with the scale.) caution use extreme care when handling calibration weights as they are very heavy. Improper lifting methods or misuse of calibration weig...
En-7 catapult 1000 series scales with the platform empty, press the on/zero off button to capture the scale zero. The display will show “-c-”. After the zero is captured, the required span calibration weight in the selected unit is displayed. Place the calibration weight on the platform and press on...
En-8 catapult 1000 series scales 5. Maintenance caution: before cleaning, turn off the scale, and remove the ac adapter. 5.1 cleaning the housing may be cleaned with a cloth dampened with a mild detergent if necessary. Do not use solvents, chemicals, alcohol, ammonia or abrasives to clean the housin...
En-9 catapult 1000 series scales 5.3 service information if the troubleshooting section does not resolve or describe your problem, contact your authorized ohaus service agent. For service assistance or technical support in the united states call toll-free 1-800-526-0659 between 8.00 am and 5:00 pm e...
En-10 catapult 1000 series scales 6.2. Drawings and dimensions figure 6-1. Catapult 1000 series overall dimensions..
En-11 catapult 1000 series scales 6.3. Compliance compliance to the following standards is indicated by the corresponding mark on the product. Mark standard this product conforms to the emc directive 2004/108/ec and the low voltage directive 2006/95/ec. The complete declaration of conformity is avai...
En-12 catapult 1000 series scales fcc note this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in ...