OHIOSTEEL 42SWP-REVD Instruction Manual - page 6
Page 6.
Step 6. Build bottom assembly. Connect bottom left tube (28), center tube (32), and bottom right
tube (29). Slide hopper bag bar (33) into the pocket provided on front bottom of the bag.
Insert bottom assembly into hopper bag. Connect the bag, bar and tubes by inserting
clevis pins (39) thru grommet on bag, bag bar, and tube. Lock it in place with hairpin
cotter (16). Repeat on other side.
Step 7. Build top assembly. Connect top left tube (30), center tube (32), and top right tube (31).
Insert top assembly in to hopper bag. Connect top and bottom tube assemblies with
clevis pin (38) and hairpin cotter as shown.
Step 8. Slide pivot rod (34) thru pivot rod plate (36) hole in side
of frame tube (30), another pivot rod plate (36), hopper
connect tube (44), and thru pocket in top front of bag,
add another hopper connect tube (44), pivot rod plate
(36) frame tube (31), pivot rod plate (36) and center.
Add flat washer (42) to each side and lock in place with
hairpin cotter (16). Bolt pivot rod plates (36) together
with 5/16 carriage bolts (40) and nylon locknut (41).
Step 9. Open bag and insert the 3/16" dia rods (35) into the
holes at the rear top and rear bottom of the steel
bag frame. Secure bag to frame with velcro tab.
35
30
32
31
32
29
28
Hopper Bag and Frame Assembly
TOP ASSEMBLY
BOTTOM ASSEMBLY
VELCRO
HOPPER BAG
BAR POCKET
PIVOT ROD
38
33
39
39
16
16
16
16
36
44
44
42
VELCRO
36
38
41
40
42
34
41
40