OHM DSP-A3 User Manual - page 9
Manual is about: Switchmode Amplifier
of
19
DSP-A3
DSP-A3
Operating Mode
1. Stereo Operation
Two fully independent amplifier channels for (normal operating mode)
Select preset “ Stereo mode” to enable normal stereo operation (see “Presets” on page 8)
2. Bridge
Operation
Mono
The input signal is taken from the channel A input.
Connect the + of your loudspeaker to pin 1+ of channel A output, and the - of your loudspeaker
to pin 2+ of channel A output.
Select preset “ Bridge Mono mode” to enable Bridge operation (see “Presets” on page 8)
10