OJ Electronics WLM-1FS User Manual - page 3
Service menu
Push accept to enter
No setting values can be changed under the service menu. The controller will automatically return
to main menu after 30 minutes.
Software version
OK no failures
E1 to E9 if a failure is present. See below for explanation.
Push accept to enter and see which unit has the
failure
Read-out
Outdoor temperature
Read-out
Actual supply water temperature
Read-out
Calculated setpoint by the controller for the supply water temperature
Read-out
Control signal for the mixing valve.
At 10V the mixing valve is fully open.
Read-out
Room temperature in the different rooms.
Push accept (V) and up or down to select another room
The room temperature is shown in the middle.
If a limitation sensor is connected the measured temperature is shown
below or above the room temperature.
·
if the thermostat is for minimum limitation the value is shown below
·
If the thermostat is set for max. limitation the value is shown above.
Return
1.6
49.2ºC
-2.4°C
44.4ºC
3.5V
---
24.0°C
22.9°C
Submenu 2
Submenu 2a
Settings
House temperature
20ºC
Night temperature
15°C
Off temperature
5°C
Floor Limit temp high
27°C
Floor Limit temp low
17°C
Max water temperature
55°C
Weather compensation
Cold (winter)
Weather compensation
Warm (summer)
Software version
Outdoor temperature
water temperature
Outdoor temperature
water temperature
1.60
Factory settings
Own settings
Factory settings
-3ºC
45ºC
25ºC
30ºC
Own settings