Copyright © ok international, inc. 7000-0770_h mx-ds1 desoldering gun for the mx-500p & mx-5200 series mx-ds1 u ser guide test equipment depot - 800.517.8431 - 99 washington street melrose, ma 02176 testequipmentdepot.Com.
1 with power applied, the tip temperature can be > 300°c. Failure to observe the following precautions may lead to injury to users or damage the equipment: • do not touch any metallic parts of the hand-piece • do not use near flammable items • do not use unit for any function other than described in...
2 introduction the mx-ds1 is a hand-held desoldering tool which utilizes shop air to create a powerful venturi vacuum to clean through-holes quickly and efficiently. Paper solder collection liners within the hand-piece barrel are easy to maintain and are an improvement upon traditional glass tubes. ...
3 choosing the correct desolder cartridge proper tip cartridge selection is important for getting the best results from your metcal system. Choosing the right tip cartridge will maximize your performance at the lowest possible temperature. Since changing the tip cartridge is so quick and easy, there...
4 maintenance: cleaning the collection chamber warning: although the desolder tool can be opened and cleaned while the system is on, the cartridge will be hot. Use extreme caution when opening the tool so as to avoid burning your fingers or hand on the exposed cartridge 1. Open the desoldering handl...
5 maintenance: cleaning the workstand the exterior of the workstand can be cleaned with a soft bristle brush and a mild detergent. The cradle can be cleaned separately by removing the attachment screw, located on the bottom of the workstand. Maintenance: replacing the swivel bushing 1. Turn off shop...
6 7. Next, tuck the other short side. 8. Finish with the long sides. Troubleshooting guide: desoldering tool does not remove solder 1. Check if the tip is heating up by applying solder to the tip. If it does not heat, follow the steps under “tip will not heat” earlier in this manual. 2. Turn the pow...
