Okayo C 7192C Operating Instructions Manual - page 5
Okayo Wireless Audio Link System
Okayo Wireless Audio Link System
8
5
1.
2. 3.
4.
7.
6.
Fig. 5: Transmitter Module
1. LCD screen
2. TX transmitting indicator
3. AF transmitting indicator
4. AF audio level indicator
5. Frequency set button
6. Up/down frequency adjustment buttons
7. Power switch & AF level control
5.
1. Power switch
2. Wired mic volume
3. Wired mic transmission indicator
4. Aux/Line input volume
5. Aux/line input transmission indicator
6. Transmitter module (see Fig. 5)
7. Headphone volume
8. 6.35mm headphone jack
9. Antenna TNC connector
10. Aux/Line stereo RCA output
11. Aux/Line stereo RCA input
12. Balanced 3 pin XLR input
13. Condenser mic p/supply selector (5V)
14. 6.35mm jack input
15. DC power loop output socket
16. DC power input socket
1.
2.
3.
4.
5.
7.
6.
8.
9.
10.
11.
12.
13.
15.
14.
16.
4.
5.
6.
7.
8.
9.
10.
3.
2.
1.
Fig. 10: Beltpack UHF Wireless Transmitter (C 7195C)
1. Aerial
2. Mute button (top)
3. On/off switch (top)
4. Mini XLR 3 Pin input socket (top)
5. LED power indicator
6. Sensitivity selection switch (side)
7. 3.5mm aux input socket (side)
8. Frequency set button
9. Up/down frequency adjustment buttons
10. Charging jack
C 7195C Lavalier Beltpack Transmitter - Figure 10.
1. Ensure microphone is switched off before inserting batteries.
2. Remove battery clip. Insert two AA batteries (alkaline or rechargeable’s are recommended).
3. Press the top mounted power button to switch to ON. The power LED will illuminate red and ‘ON’ will be displayed
on the LCD screen. repeat this to switch OFF
4. A selection switch on the side of the beltpack provides three level settings (low, mid & high) depending on the appli-
cation or environment in which it is to be used. The mute button allows beltpack to be put on standby without
switching the power off.
5. The LCD screen will display the channel selected. To determine which frequency this channel is operating on, press
the UP or DOWN frequency adjustment buttons.
6. Press the frequency set button for one to two seconds. The LCD screen will flash the currently selected channel
number. You can cycle through the channels by pressing the UP or DOWN frequency adjustment buttons. Press the
frequency set button again to lock in your channel selection.
7. The battery status is displayed on the left of the screen. When battery capacity is critical the icon will flash three
times before switching the microphone off automatically.
8. When using with rechargeable NiMH batteries, you can use the C 7196A charging pod. This allows you to put up to
two beltpacks on charge at the same time. Charging time is dependant on the capacity of batteries used, typically
10-12 hours charging is required. If battery icon is flashing when charger is connected, ensure rechargeable batter-
ies are inserted in the microphone. If batteries have failed both the battery icon and screen backlight will flash.
During normal charging the battery icon will cycle through the charge “bar” icons. Once full capacity is reached the
full battery icon and all “bars” will be displayed.
Fig. 6: Transmitter Front & Rear Panel