Oki OF5780 User Manual - page 14
14
Network print server
|
Setting Up the Network Print
ServerUsing the Front Panel (LCD
Display)
You can configure the IP Address, Subnet Mask and Gateway
address for the network print server from the fax machineís
front panel. The front panel procedure is described below.
IP Address Setup
!
When printing with a NetWare server, the IP Address
configuration may not be necessary if Novellís IPX/SPX
protocol is used, since there will be auto-discovery of
the print server.
The network print server automatically uses DHCP to discover
the IP address if your network has a DHCP server running. If
not, check with your network administrator for the correct IP
address, subnet mask and default gateway values to use.
1 At the fax machineís front panel, press the MENU key.
2 Using the arrow keys, select 10:SETUP, then press Enter.
3 Using the arrow keys, select 7:LAN OPTIONS, then press
Enter.
4 Using the arrow keys, select 83:IP ADDRESS, then press
Enter. Type in the correct IP address using the numeric
keypad. To correct an entry, press the ìleftî key to move
back, then re-enter the desired number. Press Enter to
register the value.
!
If an IP address octet is less than three digits, use the
shift arrow key to move to the next octet.
5 Repeat step 4 for 84:SUBNET MASK and 85:DEFAULT
GATEWAY.
6 Press MENU/EXIT.
!
The fax machine takes 5 seconds to reconfigure
after pressing the MENU/EXIT key. Do not turn the
machine off during this period. If you select another
setting during the configuration period, ìFUNC. NOT
AVAIL.î displays.
Printing a Configuration Page from the fax
machine Front Panel
1 At the fax machine front panel, press the MENU key.
2 Use the arrow keys to select 8:REPORT PRINT, then
press Enter, then move the cursor to 9:NIC
CONFIGURATION.
3 Press ENTER.
The configuration page prints.