Oki OKILAN 310Eplus Installation Manual

© 1998, Okidata

OKILAN 310e+ Installation Guide

Warning: Disconnect the printer from a.c.

power before installing board.

➊ Use SIMM 1 slot for additional

memory only.

Turn the printer around so that the rear is facing you.

Use a screwdriver to remove serial interface board from back panel

of printer.

If a SIMM module is present on the serial interface board, you will

need to migrate it to the SIMM 1 slot on the OKILAN 310e+ card

(see Installing SIMM Options, step 1, below).

Locate guide rails ➊ and edge connector

 ➋.

Insert  the OKILAN 310e+ into the

printer making sure that the board

locates in the guide rails. Push the

board firmly into place. Tighten the

screws (if fitted) on the option

board. If the screws do not locate,

the board may not be properly

seated.

➋ Use SIMM 2

for  FLASH ROM option only.

Insert the gold metallic

contact edge of the

SIMM firmly into the

socket at a 30 degree

angle.  Bring the SIMM

upright to a 90 degree

angle until the SIMM

clicks into place.

After you have installed the Network Print Server:

Confirm that your printer recognizes the new components, including

any additional RAM memory, by printing the menu. Refer to your

printer's User's Guide for this procedure. Refer to your OKILAN 310e+

Network Administrator's Guide for additional information regarding

configuring and cabling details.

1

2

3

4

1

2

➋

➊

Installing SIMM Options

5

➊

➋

 2000 Bishops Gate Blvd. Mt. Laurel, NJ 08054 1-800-OKIDATA (800-654-3282)

 Fax: 856-222-5247  http://www.okidata.com

© 1999 Okidata