P.Audio system co., ltd. Xt-15sub: 1200w (peak) active 15” subwoofer.
Read all of the instructions included in this manual the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operation and maintenance instructions. The lightening flash with arrowhead symbol within an equilateral triangle is intended to alert ...
Introduction thank you for purchasing the xt-15sub, and for your faith in us and our products. This subwoofer will provide you many years of useful service with proper use and care. Please read this manual completely and become familiar with the design and operation of this advanced active speaker s...
* note: max acoustic output is based on smoothed system response, not peak driver response. P.Audio is continually looking to improve products, so specifications are subject to change without notice. Features and applications the xt-15sub can be used in a wide range of scenarios, whether fixed insta...
2. Portable sound reinforcement: 2 xt-15sub with 2 xt-10 setup and use of the xt-15sub note: the xt-15sub uses a switchable ac mains power supply. It is the responsibility of the user to insure that the ac mains are set to the correct ac voltage. This voltage is either 115vac or 230vac. The correct ...
Prior to connecting the ac mains cable, ensure that the ac mains switch is in the off position. The xt-15sub will operate on ac mains voltages of 115 volts or 230 volts. The required ac mains frequency is between 50 hz and 60 hz. The acceptable voltage range is 104vac- 126vac and 207vac-253vac. Plea...
The input connector should be used for the main full-range audio input signal and the high- pass filtered output should be connected to the associated mid-hi speakers. The high-pass filtered output has a 4 th order, 24 db-per-octave filter at 120 hz. All program material between 40 hz and 120 hz is ...
Rigging and suspension the x9 sub is intended to be used with a standard m20 screw thread style satellite pole mount (available from p.Audio) for mounting the xt-8 or xt-10 above it. The xt-15sub must be located on a level surface that is capable of safely supporting the weight of both the xt-15sub ...
Problem: distorted sound when input levels to the xt-15sub amplifier exceed 0.775 v rms it is possible to produce system clipping or overdrive. It is still possible to “overdrive” the input section of the enclosure. If distorted sound is present the following steps should be taken: 1. Verify that th...
The x9 amplifier module must be serviced by a company authorized by p. Audio. Replacement of components replacement of components must be performed by a qualified technician or one knowledgable in the replacement of transducer components! Do not attempt any repairs unless the xt-15sub amplifier has ...
Please scan this qr code for quick access to the p.Audio website. P audio system co., ltd. 19/4 moo 2 t.Bangkratuk a.Samparn , nakornpathom. 73210,thailand tel: +66-2-441 6600 (auto 30 lines) fax: +66-2-441 6699 website: www.Paudiothailand.Com e-mail: info@paudiothailand.Com.
