- DL manuals
- P3 International
- Thermometer
- E9310
- Operating Manual
P3 International E9310 Operating Manual
Summary of E9310
Page 1
Wireless pool thermometer e9310 operating manual.
Page 2
Please read these instructions carefully from start to finish before initial start-up to avoid functional breakdown and faulty operation. The manual contains important informa- tion about the installation and operation. Keep the manual available for future reference. If you sell or give away this un...
Page 3: Content
Content 1. General information and function ................................................ 4 2. Intended usage ............................................................................ 4 3. Safety instructions ....................................................................... 5 4. Battery ...
Page 4: 2. Intended Usage
1. General information and function this wireless battery-operated pool thermometer is a high quality instru- ment which will measure the water temperature in swimming pools, garden ponds, spas, etc. It is water-proof and will float on the water‘s surface. The thermometer includes a temperature disp...
Page 5: 3. Safety Instructions
3. Safety instructions we shall not assume any liability for damage to items or persons caused by improper handling or non-observance of the safety instructions! In such cases, any guarantee claims shall become null and void. - do not use this product in hospitals or medical institutions. Although t...
Page 6: 5. Preparing For Operation
5. Preparing for operation 5.1. Open the housing - rotate the unit and unscrew the 6 screws (see below) - lift up the upper part carefully. 5.2. Inserting the batteries - the unit is operated with 3 x 1,5 v aa batteries. Use alkaline batteries for longer life and better protection against leaking. -...
Page 7: 6. Operation
When you open the unit, you will see the dip switch located on the circuit board (see diagram below). The dip switches numbered 1-3 are used for addressing. The dip switch numbered 4 is used for choosing measuring units (ºf or ºc). The default values set at the factory are address 8 and degrees fahr...
Page 8: 6. Operation
6. Operation gently set the tightly closed unit on the water‘s surface. Wait until the temperature display shows a stable value. The temperature of the inner housing will take some time to match the water tempera- ture. Caution! Do not throw the unit into the water. Do not use the unit as a toy or s...
Page 9: 8. Maintenance
8. Maintenance 8.1. Changing the batteries - if the flat battery symbol appears in the display (lo bat) all batteries must be changed for ones of the same type as described in section 5.2 (p. 6). Always change all 3 batteries and use only high-quality alkaline cells. 8.2. Cleaning - clean the unit u...
Page 10: 10. Technical Data
0 10. Technical data measurement range: ......................................32˚f to 158˚f (0˚c to 70˚c) resolution: .................................................................................. 0,1˚f/˚c accuracy: ..............................................................................±1...
Page 11: 11. Fcc Information
11. Fcc information fcc id: rnt-pt3 changes or modifications not expressly approved in writing by p3 inter- national corporation may void the user’s authority to operate the equip- ment. Note: this equipment has been tested and found to comply with the limits for a class b digital device, pursuant t...
Page 12
P3 international corporation limited warranty p3 international corporation („p3“) warrants to the original retail purchaser only, that its product is free from defects in material or workmanship under the condition of normal use and service for a period of six (6) months from the date of purchase. I...