Kill a watt™ ez .................................................................................... Operation manual p4460 kill a watt tm ez p.F. $ elapsed time menu up down reset set total year month week day hour cost rate volt hz amp % watt kwh va hour.
Thank you for purchasing the p4460 kill a watt™ ez power meter. This operating manual will provide an overview of the product, safety instructions, a quick guide to operation, and complete instructions for correct usage. Take the time to completely review these instructions as well as all safety war...
Read instructions – all the safety and operating instructions should be read before the product is operated. Retain instructions – the safety and operating instructions should be retained for future refer- ence. Heed warnings – all warnings on the product and in the operating instructions should be ...
Water and moisture – do not use this product near water – for example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool and the like. Accessories – do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fal...
Object and liquid entry – never push objects of any kind into this product through openings (if any) as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. Servicing – do not attempt to service this ...
Quick start guide: use these quick start instructions to get up and running in just a few minutes. Be sure to review all the operating instructions later to ensure full enjoyment of the product. 1. Connect the kill a watt™ ez unit to the outlet and the appliance to the unit 2. Press and hold the res...
Installation: 1. Remove the protective film (if any) covering the lcd meter display by pulling the tab marked “remove before use”. 2. Turn off the appliance and remove the power cord from the outlet. Connect the kill a watt™ ez unit to the outlet and the appliance to the unit. If the outlet is in an...
Ance since the last reset. This cost is calculated based on the total consumed power in kwh and the utility rate that you have set. 3. Don’t be surprised if the total cost display is 0.00 initially. It will take some time to accumulate cost. 4. Pressing the up and down key will cycle through the cos...
Lcd can display meter readings such as volts, current, watts, frequency, power factor, and va. 2. To cycle through the various measurements press the up and down key as desired. The measurement unit currently selected will be indicated in the display. 3. Volts are displayed in volts (true rms), curr...
Release the reset key. This indicates that previous measurements have been deleted and that the total accumulated kwh, elapsed time and cost measurements have been reset to zero. Retained measurements: 1. When power to the kill a watt™ ez is interrupted, the display will go blank and the unit will s...
P3 international corporation limited warranty p3 international corporation (“p3”) warrants to the original retail purchaser only, that its product is free from defects in material or workmanship under the condition of normal use and service for a period of six (6) months from the date of purchase. I...
