Operation and maintenance manual for ads200 soldering system w/td-200 handpiece manual 5050-0589 rev. Date 4/1232018 this manual applies to: model firmware revision required power part number ads200 w/standard tool stand 1-2 120 vac 8007-0578 ads200 w/isb tool stand 1-2 120 vac 8007-0579 ads200 w/st...
Table of contents general information.................................................................................................................................. 1 introduction.........................................................................................................................
?2018 pace inc., vass, north carolina, all rights reserved page 1 general information introduction thank you for purchasing the ads200 soldering system. This manual will provide you with the information necessary to properly set up, operate, and maintain your system. Please read this manual thorough...
?2018 pace inc., vass, north carolina, all rights reserved page 2 power supply features safety guidelines the following are safety precautions that personnel must understand and follow when using or servicing this product. 1. Potential shock hazard - repair procedures on pace products should be perf...
?2018 pace inc., vass, north carolina, all rights reserved page 3 system set-up set up the accudrive® system using the following steps. 1. Store the shipping container in a convenient location. Reuse of these containers will prevent damage if you store or ship your system. 2. Place the power switch ...
?2018 pace inc., vass, north carolina, all rights reserved page 4 system power 1. Insert the female end of the power cord into the ac power receptacle on the rear panel of the power source. 2. Plug the prong end (male end) of the power cord into an appropriate 3 wire grounded ac supply receptacle. S...
?2018 pace inc., vass, north carolina, all rights reserved page 5 digital led display - normal operation the digital led display provides a 3-digit display of information. The led display can show: 1. "888" on initial power up to ensure that all sections of the display are working. 2. The software v...
?2018 pace inc., vass, north carolina, all rights reserved page 6 customizing your system the menu driven led display of the systems allows you to easily customize your system. In set-up mode, you can: • enter, remove or change a password. • set the default temperature scale to °f or °c. • change th...
?2018 pace inc., vass, north carolina, all rights reserved page 7 temperature limits 5. The digital display will show the stored default high ("hi") temperature limit by alternating to show "hi" and the stored limit. Choose one of the following: • press and release the program key ( ) to keep the st...
?2018 pace inc., vass, north carolina, all rights reserved page 8 autooff what is autooff? When enabled, the autooff safety feature turns off the power to the handpiece after a pre- selected time (between 10- 90 minutes) from the system entering temperature setback. When the system has entered tempe...
?2018 pace inc., vass, north carolina, all rights reserved page 9 setback temperature 11. The digital display will now alternate between “sbt” and a temperature. This is the temperature that the system will go to anytime the system goes into setback, either from the built-in timer or from the instan...
?2018 pace inc., vass, north carolina, all rights reserved page 10 power source most malfunctions are simple and easy to correct. Symptom probable cause solution no power to system blown fuse replace the fuse (located in the ac receptacle fuse holder) with one of the same rated value. Defective tip-...
?2018 pace inc., vass, north carolina, all rights reserved page 11 optional accudrive® blue series tip-heater cartridges for optimum thermal performance, always select the shortest, widest tip with the maximum contact surface area with which you can safely access the work. Standard tips for delicate...
?2018 pace inc., vass, north carolina, all rights reserved page 12 pace limited warranty statement limited warranty seller warrants to the first user that products manufactured by it and supplied hereunder are free of defects in materials and workmanship for a period of one (1) year from the date of...
