1. DL manuals
  2. Pace
  3. Soldering Gun
  4. ST 25
  5. Operation And Maintenance Manual

Pace ST 25 Operation And Maintenance Manual

Other manuals for ST 25: Operation And Maintenance Manual

Summary of ST 25

  • Page 1

    Worldwide operation and maintenance manual for the st 25 & st 35 soldering systems p/n 5050-0452 rev d.

  • Page 2

    ©2001 pace inc., laurel, maryland page 2 of 14 all rights reserved title test .............................................................................................................. Page general information introduction ............................................................................

  • Page 3

    ©2001 pace inc., laurel, maryland page 3 of 14 all rights reserved introduction thank you for purchasing the pace model st 25 or st 35 digital soldering system. This manual will provide you with the information necessary to properly set up, operate and maintain the st 25 or st 35. The st 25 and st 3...

  • Page 4

    ©2001 pace inc., laurel, maryland page 4 of 14 all rights reserved english language safety guidelines the following are safety precautions that personnel must understand and follow when using or servicing this product. 1. Potential shock hazard - repair procedures on pace products should be performe...

  • Page 5

    ©2001 pace inc., laurel, maryland page 5 of 14 all rights reserved sicherheit korrekturlinien, deutsche sprache die nachfolgenden sicherheitsvorschriften sollten vom bedien- un servicepersonal verstanden und befolgt werden. 1. Entladung spannungsfuehrender teile - reparaturen an pace produkten sollt...

  • Page 6

    ©2001 pace inc., laurel, maryland page 6 of 14 all rights reserved guidelines de segurança, portuguese lingua segeum-se precauções de segurança que os operadores devem compreender e seguir ao utilizar ou reparar produtos pace. 1. Perigo de choque eléctrico - os procedimentos de reparação em produtos...

  • Page 7

    ©2001 pace inc., laurel, maryland page 7 of 14 all rights reserved säkerhetsföreskrifter, svenska följande säkerhetsföreskrifter måste förstås och följas av personal som använder eller utför service på pace produkter. 1. Risk fÖr strÖmstÖt - service / reparation av pace produkter får endast utföras ...

  • Page 8

    ©2001 pace inc., laurel, maryland page 8 of 14 all rights reserved system set-up set up the st 25 or st 35 system using the following steps and associated drawings. 1. Store the shipping container in a convenient location. Reuse of these containers will prevent damage if you store or ship your syste...

  • Page 9

    ©2001 pace inc., laurel, maryland page 9 of 14 all rights reserved 2. Plug the prong end (male end) of the power cord into an appropriate 3 wire grounded ac supply receptacle. Caution: to insure operator and esd/eos safety, the ac power supply receptacle must be checked for proper grounding before i...

  • Page 10

    ©2001 pace inc., laurel, maryland page 10 of 14 all rights reserved operation variable temperature control adjust the variable temperature control knob to the desired temperature setting. Notice that the control dial has a white graphic scale denoting temperature in °c (celsius) and a yellow graphic...

  • Page 11

    ©2001 pace inc., laurel, maryland page 11 of 14 all rights reserved temperature is off by more than ±15°c, the handpiece may require maintenance. Recheck the temperature using a second handpiece. 4. Carefully lock the variable temperature control in position by tightening the inner set screw (closes...

  • Page 12

    ©2001 pace inc., laurel, maryland page 12 of 14 all rights reserved oxidation build-up in heater bore clean heater bore using wire brush no ground on tip check resistance: pin 4 to a new tip. Resistance should be less than 2 ohms, if not see solution defective heater replace heater assembly heater s...

  • Page 13

    ©2001 pace inc., laurel, maryland page 13 of 14 all rights reserved 4 retaining nut for ps-70/ps-90 1410-0122-p5 5 tip & temperature selection chart 5050-0251 6 replacement pcb assembly 6020-0120-p1 table 4: spare parts service please contact pace or your local distributor for service and repair. Wa...

  • Page 14

    ©2001 pace inc., laurel, maryland page 14 of 14 all rights reserved pace, incorporated retains the right to make changes to specifications contained herein at any time, without notice. The following are registered trademarks and/or service marks of pace, incorporated, laurel, maryland, usa and may o...