PACIFIC CYCLE Double Seat Fixed WheelJogging Stroller User manual - Attach The Front Wheel
7
Attach the Front Wheel
3.
1.
2.
4.
Calibrate the Front Brake
WARNING!
Incorrect brake calibration or not having the brake
engaged may cause the stroller to fail to stop and
result in serious injury or death. Always check the
brakes are functioning properly before use.
Lower the brake quick release lever and close
the front brake.
1.
2.
Spin the wheel and make sure the brake pads
do not rub and are correctly aligned.
If the alignment is not correct then loosen the
brake pad nut, spin the wheel and align the
brake pad. After correctly aligning the brake,
hold the brake pad in place and retighten the
brake pad nut.
If the brake pads are rubbing the wheel, turn
the barrel adjuster a few turns.
If the barrel adjuster has been turned all the
way and the pads still touch the wheel, the
cable will have to be adjusted.
Loosen the cable anchor nut. Using pliers,
pull the loose cable until taught and so the
pads are at the correct distance. Retighten
the cable anchor nut.
3.
WARNING!
If the front wheel is not securely locked in place it
may fall off the Jogging Stroller and cause serious
injury or death. Always check the front wheel is
securely locked in place before use.
Position the stroller so the handle rests on
the ground. The fork front will be facing up.
Move the quick release lever into the
open position.
Set wheel into the forks, ensure the axle is
properly seated, and hand tighten the cone
nut.
Close the quick release lever to the fully
closed locked position. When closing the
lever it should leave an imprint on your hand.
The lever should have firm but not excessive
pressure.
Pull on the wheel to ensure it is locked in
place. If necessary loosen the quick release
lever and retighten the cone nut. Re-check
the wheel.
5.
Quick
release
lever
4.
5.
2
Quick release
lever
Brake pads
Cable anchor nut
3
1
Center nut
Barrel
adjuster
6.
Cone nut
Meijer.com