PACIFIC CYCLE Reach Road Racing Owner's Manual

Summary of Reach Road Racing

  • Page 1

    Reach road racing owner manual reach road racing owner manual.

  • Page 2: Reach Features

    Reach road racing owner manual reach features • the riding geometry of full sized road bikes. • the gear ratio of full sized road bikes - 30~118 inch. • effective front and rear suspension. • rigid small wheels for agile acceleration and fast stopping. • small front area for better aerodynamics. • s...

  • Page 3

    Reach road racing owner manual specification frame built of al7005 t6 aluminum, rigid front triangle and rear swing arm with rear shock front fork built of al7005 t6 aluminum, trailing link suspension tires/tubes primo comet 20”x1-1/8” (26-451) skin wall 110psi. French valves rims alex r-390 451x13 ...

  • Page 4: Assembly Procedures

    Reach road racing owner manual assembly procedures step 1: unpack the box – (1) a 90% assembled reach, (2) stem, (3) stem raiser, (4) seat / seat post, (5) front wheel / qr, and (6) pedals. 4.

  • Page 5: Step 2:

    Reach road racing owner manual step 2: assemble the stem to the gooseneck, and insert the stem raiser into the head tube, adjust the handlebar height and alignment, close the qr lever on top of the stem. Note: do not raise the seat higher than the minimum insertion mark. 5.

  • Page 6: Step 3:

    Reach road racing owner manual step 3: assemble the saddle and seat post, insert the seat post into the seat tube, and close the seat clamp qr lever. 6 note: do not raise the seat post higher than the minimum insertion mark..

  • Page 7: Step 4:

    Reach road racing owner manual step 4: slide the front wheel into the front fork with both ends of hub sitting on the dropouts. Insert the hub skewer into the front hub. Let the qr lever on the left side of you. Align the center of the wheel. Close the qr lever at proper tightness. Hook the brake ca...

  • Page 8: Step 5:

    Reach road racing owner manual step 5: assemble the pedals into the cranks. 8 step 6: adjust the height and alignment of seat post and handlebar. Note: do not raise the seat and handlebar over the minimum insertion mark..

  • Page 9: How To Fold

    Reach road racing owner manual 9 how to fold level 1. Take off front wheel and seat. Use two m5 allen key to release the rear suspension. Swing the rear swing arm to let the rear wheel go into the front fork.* pull out the handlebar stem. Put it into the car trunk. *note: shift to the chain to the l...

  • Page 10: How To Fold

    Reach road racing owner manual 10 how to fold level 2. Take off the rear wheel, pack the bike in a carrying bag for travel..