Warning: if the information in these instructions is not followed exactly a fire or explosion may result causing property damage, personal injury or death. Installer: leave this manual with the appliance. Consumer: retain this manual for future reference. This appliance is suitable for installation ...
Bdwy.Bodyb brnt.Bodyb table of contents important note for the commonwealth of massachusetts: ...... 3 caution ...................................................................................... 4 safety ......................................................................................... 5 f...
Bdwy.Bodyb brnt.Bodyb important note for the commonwealth of massachusetts: from massachusetts rules and regulations 248 cmr 5.08: (a) for all side wall horizontally vented gas fuelled equipment installed in every dwelling, building or structure used in whole or in part for residential purposes, inc...
Bdwy.Bodyb brnt.Bodyb this fireplace is equipped with a micro mesh safety screen for your protection and must be installed with the unit. Removal of the safety screen will cause the fireplace to become a burn hazard. Caution for your safety - do not install or operate your town & country fireplace w...
Bdwy.Bodyb brnt.Bodyb safety • due to high temperatures, this gas appliance should be located out of traffic and away from furniture and draperies. • children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. • young ch...
Note: fireplace may take up to 30 seconds to ignite each time the “on” button has been selected first fire congratulations on your purchase of a pacifi c energy gas appliance. Your fi replace has been professionally installed by: dealer name: ___________________________________________________ phone...
Remote control operation system description the profl ame 2 remote control system consists of two elements: 1. Profl ame 2 remote control transmitter. 2. Profl ame integrated fireplace control (ifc) (figure 3) board and a wiring harness to connect the ifc to the gas valve and stepper motor - see “fi...
Ifc module the proflame 2 integrated fireplace control (ifc) module (figure 3) is a device that allows automatic ignition and pilot flame supervision, and commands the functions of the hearth heater. It’s configured to control the on/off main burner operation, giving the choice of both ipi (intermit...
Figure 6: temperature in celcius. Figure 7: temperature in fahrenheit. Figure 8: key lock icon. Bdwy.Bodyb brnt.Bodyb the thermostat key (figure 1) on the remote handset needs to be held down. Keep it pressed down and remove one of the three batteries from the remote handset. Simply re-install the b...
Bdwy.Bodyb brnt.Bodyb remote flame control the proflame has six (6) flame levels. With the system on, and the flame level at the maximum in the appliance, pressing the down arrow key once will reduce the flame height by one step until the flame is turned off. The up arrow key will increase the flame...
Bdwy.Bodyb brnt.Bodyb smart thermostat (transmitter operation) the smart thermostat function adjusts the fl ame height in accordance to the difference between the set point and the room temperatures. As the room temperature gets closer to the set point, the smart function will modulate the fl ame do...
Low battery power detection transmitter the life span of the remote control batteries depends on various factors: quality of the batteries used, the number of ignitions of the heater, the number of changes to the room thermostat set point, etc. When the remote batteries are low, an icon will appear ...
Continuous pilot/intermittent pilot (cpi/ipi) selection bdwy.Bodyb brnt.Bodyb maintenance caution: turn off gas and electrical power supply (if applicable) and allow ample time for unit to cool before servicing appliance. It is recommended that the fireplace and its venting should be inspected at le...
Bdwy.Bodyb brnt.Bodyb lighting instructions 14 230216-44 5055.66-b.
Figure 19: broadway dimensions. Figure 20: brentwood dimensions. Bdwy.Bodyb brnt.Bodyb fireplace dimensions broadway: brentwood: 15 5055.66-b 230216-44.
Figure 21: cavity dimensions. Dimension broadway brentwood a 13” 15” b 21” 23” c 26” 34” bdwy.Bodyb brnt.Bodyb existing fireplace preparation the broadway and brentwood gas inserts are certified to be installed into pre-existing approved fire place cavities. The minimum cavity requirements are liste...
• fireplace surround fronts located onpage 25. • fireplace surrounds and oversize backing plates for larger fi replace openings located on page 25. • fronts and surrounds part numbers located on page 37. Figure 22: mantel clearances. 8” 8” figure 23: sidewall clearances. * note on hearth distance req...
Figure 24: flue adapter plate connections. Figure 25: high wind vent terminal. Bdwy.Bodyb brnt.Bodyb figure 26: co linear venting. Venting note: the following simpson duravent kits are recommended for use with this appliance. High-wind (broadway 46dva-cl33) (brentwood 46dva-cl34) prairie co-linear k...
Figure 27: gas and electrical connections. Bdwy.Bodyb brnt.Bodyb plumbing and electrical note: installation requires that an electrical outlet be installed into existing fireplace cavity before insert is installed. To make the required electrical and gas connections start by positioning the gas inse...
Bdwy.Bodyb brnt.Bodyb gas supply gas pressure requirements input pressure natural gas propane minimum 5.0” wc 11.0” wc maximum 13.9” wc 13.9” wc manifold pressure high 3.5” wc 10” wc low 1.6” wc 6.4” wc gas pressure check / output / efficiency broadway gas orifice output afue ng 1.98mm 18,000 btu/hr...
Figure 28: valve location. Figure 29: valve. Bdwy.Bodyb brnt.Bodyb gas pressure testing procedure battery holder pilot adjustment the pilot flame level can be adjusted by turning the adjustment screw, using a flat-tip screwdriver, seen on the valve in figure 29. Note: to test the gas pressure, turn ...
Figure 31: pilot shield. Pilot shield spring hood orifice figure 32: pilot hood and orifi ce. Figure 33: venturi opening. Bdwy.Bodyb brnt.Bodyb propane conversion pilot orifice sizes ng - #62 lp - #35 before starting the conversion make sure to shut off the gas supply to the unit and allow fi replac...
Bdwy.Bodyb brnt.Bodyb door installation/removal adjustable leveling bolts this fireplace comes with two leveling bolts used to adjust the angle of the front of the fireplace relative to the wall in which it’s installed. The bolts are not pre-installed and can be found in a separate plastic bag. Care...
Bdwy.Bodyb brnt.Bodyb surround installation instructions the surround cover (figure 36) attaches to the lintel once the decorative backing plate has been installed. The surround easily fi ts into place by connecting all four of its hooks to the lintels four tabs (figure 37). Figure 36: door. Figure ...
Figure 41: surround dimensions.Ai broadway contemporary surround broadway oversize contemporary surround brentwood contemporary surround brentwood oversize contemporary surround surround front dimensions mounting holes surround base screen surround front figure 40: contemporary surround. Bdwy.Bodyb ...
Bdwy.Bodyb brnt.Bodyb figure 42: door bolts location. Fan removal / installation 1. Make sure that the gas and electrical supply is shut off. Locate and remove the two 3/8” bolts securing the bottom of door as seen in figure 42. 2. Tilt the bottom of the door away from the appliance and lift the doo...
Bdwy.Bodyb brnt.Bodyb figure 45: burner hold down screw location. Figure 46: removing upper baffle. Figure 47: removing burner plate. Figure 48: removing side firebox panel. Figure 49: removing rear firebox panel. Screws removing the burner and burner tray. 1. Remove the screw holding the burner to ...
Bdwy.Bodyb brnt.Bodyb figure 53: nut location. Figure 50: back ledge removal. Figure 51: removing base plate. Figure 52: base plate moved to the right side. 5. Remove two screws which hold the back ledge (figure 50) in place and remove. 6. Remove the approximately 25 screws hold the base plate (figu...
Bdwy.Bodyb brnt.Bodyb figure 54: removing blower fan. Figure 55: blower fan. 8. The fan is located inside the opening and toward the rear of the firebox. A 3/8” nut holds the fan assembly onto a threaded post. Remove the nut and gently extract the fan assembly from the fire box (figure 54). Be caref...
Bdwy.Bodyb brnt.Bodyb figure 56: panel set. Figure 57: rear panel. Figure 58: side panel. Panel installation / removal installation 1. Insert back panel so that it is sitting on ledge at the back of the fi rebox as shown in figure 57. 2. Insert fi rst side panel by inserting the front edge of the pa...
Bdwy.Bodyb brnt.Bodyb installation position the air deflector in the fireplace as seen in (figure 61) and secure with two screws using a screwdriver. Removal remove the two screws seen in (figure 61) using a screwdriver, and remove the air deflector from fireplace. 1. 2. Repeat step 2 to remove seco...
Bdwy.Bodyb brnt.Bodyb figure 63: burner. Burner tray installation / removal screws figure 62: burner tray. Figure 64: burner components. Installation place burner in firebox so that the venturi is over top of the orifice. To secure burner insert screw using a screwdriver as seen in figure 63. Remova...
Bdwy.Bodyb brnt.Bodyb figure 65: log set. Figure 66: rear log installation. Figure 67: front log installation. Figure 68: decorative log installation. Figure 69: ember placement. Figure 70: complete log set. Log set installation / removal installation 1. Position rear log against the back fi rebox a...
Bdwy.Bodyb brnt.Bodyb figure 71: rustic log set. Figure 72: rustic rear log installation. Figure 73: rustic front log installation. Figure 74: rustic side log installation. Figure 75: rustic decorative log installation. Figure 76: rustic complete log set. Rustic log set installation / removal instal...
Bdwy.Bodyb brnt.Bodyb figure 77: glass burner kit. Figure 78: air deflector - glass burner. Screws figure 79: burner tray - glass. Figure 80: glass installation. Figure 81: rock placement. Glass burner installation / removal air deflector installation / removal installation position the air deflecto...
Bdwy.Bodyb brnt.Bodyb damper/air shutter figure 82: air shutter. The bristol and bedford fireplaces both come with an adjustable damper that can limit the flow of intake air. This damper is located behind the air deflector at the rear of the inner firebox. Sometimes on installations that involve ver...
Bdwy.Bodyb brnt.Bodyb door kit (required) screen printed door ..................................... Bdem.Dspa contemporary surround (required) contemporary surround - black ................ Bdwy.Stbka contemporary surround - stainless ........... Bdwy.Stssa oversize contemporary - black ........... ...
Bdwy.Bodyb brnt.Bodyb wiring diagram caution: label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. 38 230216-44 5055.66-b.
Bdwy.Bodyb brnt.Bodyb broadway rating label b this appliance is equipped for use with / cet appareil est Équipé pour utilise avec : na tural gas lp-gas gaz na turel lp gaz for use with/ en case d’emploi avec: na tural gas/ du gaz naturel lp gas/ du gaz lp minimum supply pressure / pression minimum d...
Brentwood rating label b this appliance is equipped for use with / cet appareil est Équipé pour utilise avec : na tural gas lp-gas gaz na turel lp gaz for use with/ en case d’emploi avec: na tural gas/ du gaz naturel lp gas/ du gaz lp minimum supply pressure / pression minimum d’alimentation: (for t...
Bdwy.Bodyb brnt.Bodyb 41 5055.66-b 230216-44.
Bdwy.Bodyb brnt.Bodyb 42 230216-44 5055.66-b.
Bdwy.Bodyb brnt.Bodyb 43 5055.66-b 230216-44.
© 2016 copyright pacific energy fireplace products ltd. Reproduction, adaptation, or translation without prior written permission is prohibited except as allowed under the copyright laws. For technical support, please contact your retailer web site: www. Pacificenergy.Net 2975 allenby rd., duncan, b...
