050115-37 5056.412-e installer: leave this manual with the appliance. Consumer: retain this manual for future reference. Warning: if the information in these instructions is not followed exactly a fire or explosion may result causing property damage, personal injury or death. For your safety do not ...
2 5056.412-e important note for the commonwealth of massachusetts: from massachusetts rules and regulations 248 cmr 5.08: (a) for all side wall horizontally vented gas fuelled equipment installed in every dwelling, building or structure used in whole or in part for residential purposes, including th...
3 5056.412-e table of contents caution .............................................................. 4 safety ................................................................. 5 owners information first fire ............................................................ 6 remote control operation ......
4 5056.412-e for your safety - do not install or operate your pacific energy fireplace without first reading and understanding this manual. Any installation or operational deviation from the following instructions voids the pacific energy warranty and may prove hazardous. This appliance and its indi...
5 5056.412-e • due to high temperatures, this gas appliance should be located out of traffic and away from furniture and draperies. • children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. • young children should be...
6 owner’s information 5056.412-e congratulations on your purchase of a pacific energy gas fireplace. Your fireplace has been professionally installed by: dealer name: ___________________ phone number: _________________ if you discover any problems with your gas fireplace contact your dealer immediat...
7 owner’s information 5056.412-e ` remote control operation system description the proflame remote control system consists of two elements: 1. Proflame transmitter. 2. Proflame integrated fireplace control (ifc) board and a wiring harness to connect the ifc to the gas valve and stepper motor. Transm...
8 owner’s information 5056.412-e ifc module the proflame 2 integrated fireplace control (ifc) board (fig. 3) is a device that allows the automatic ignition and pilot flame supervision, to command the functions of a hearth appliance. It is configured to control the on/off main burner operation via a ...
9 owner’s information 5056.412-e temperature indication display with the system in the “off” position, press the thermostat key and the mode key at the same time. Look at the lcd screen on the transmitter to verify that a c or f is visible to the right of the room temperature display. (fig. 6 & 7) t...
10 owner’s information 5056.412-e remote flame control the proflame has six (6) flame levels. With the system on, and the flame level at the maximum in the appliance, pressing the down arrow key once will reduce the flame height by one step until the flame is turned off. The up arrow key will increa...
11 owner’s information 5056.412-e comfort fan speed control if the appliance is equipped with a hot air circulating fan, the speed of the fan can be controlled by the proflame system. The fan speed can be adjusted through six (6) speeds. To activate this function use the mode key (fig.1) to index to...
12 owner’s information 5056.412-e low battery power detection transmitter the life span of the remote control batteries depends on various factors: quality of the batteries used, the number of ignitions of the appliance, the number of changes to the room thermostat set point, etc. When the transmitt...
13 owner’s information 5056.412-e turn off gas and electrical power supply (if applicable) and allow ample time for unit to cool before servicing appliance. It is recommended that the fireplace and its venting should be inspected at least once a year by a qualified service person. Glass door: warnin...
14 owner’s information 5056.412-e lighting instructions.
15 installer information 5056.412-e fireplace dimensions esteem: estate: figure 17: estate dimensions figure 16: esteem dimensions.
16 installer information 5056.412-e *mantel clearance esteem estate a 19” 21” b 19” 21” c 19” 21” ** mantel depth d 12” e 9” f 6” clearances to combustibles minimum clearance to combustible materials esteem estate enclosed side wall 1.75” 1.75” enclosed back wall ncr * ncr * enclosed ceiling 4” 4” e...
17 installer information 5056.412-e figure 20: common installation location locating the fireplace in planning the installation for the fireplace, it is necessary to determine where the unit is to be installed, location of vent system and where gas supply piping may be plumbed. Various installations...
18 installer information 5056.412-e installation 1. Fasten the surround base to the fireplace using supplied screws and mounting holes located along the inner edge of the base. 2. Install the safety screen by aligning it with surround base and then pressing it into place. Note: install screen insuri...
19 installer information 5056.412-e venting note: the intake damper positions specified in this chart were set in a controlled testing environment, and serve as a general guideline for installations. Every venting configuration is different, and the damper setting may need slight adjustment from thi...
20 installer information 5056.412-e figure 28: venting components this fireplace is certified for use with 4” x 6-5/8”coaxial venting components only. It is permitted to only use certified venting for this appliance. Including certified coaxial flexible venting. Figure 25: vent terminal minimum clea...
21 installer information 5056.412-e note: mixing venting components from different manufacturers is inadvisable. Venting components figure 1: 4”x6-5/8" rigid piping cross reference chart figure 27: 4”x6-5/8" rigid piping cross reference chart figure 28: 4”x6-5/8" rigid pipe components cross referenc...
22 installer information 5056.412-e plumbing and electrical figure 29: gas and electrical connections gas connection to make the required electrical and gas connections, start by positioning the gas fireplace. Connect the gas supply line to the 1/2” fitting that extends out of the unit as seen in fi...
23 installer information 5056.412-e servicing of the appliance can be performed from the front of the unit by removing the door and the gas tray from the unit. Caution: the gas line should be installed by a qualified service person in accordance with all building codes. This section is intended as a...
24 installer information 5056.412-e gas pressure testing procedure note: to test the gas pressure, turn off the gas supply to the appliance before loosening test point screws. Verify gas pressures with the fireplace lit and at the highest setting. 1. Remove bottom trim and locate the valve as seen i...
25 installer information 5056.412-e propane conversion before starting the conversion make sure to shut off the gas supply to the unit and allow fireplace to cool to room temperature. To convert the gas fireplace from natural gas to propane the (gasc.Lpkit) kit is required. This kit comes with new p...
26 installer information 5056.412-e door installation/removal installation 1. Position the door so that the doors upper bracket is positioned overtop of the lip on top of the firebox. 2. Lower the bottom edge of the door and secure it with 3/8” bolts to the relief arms as shown in figure 34. Removal...
27 installer information 5056.412-e panel installation / removal installation 1. Insert back panel so that it is sitting on ledge at the back of the firebox as shown in figure 37. 2. Insert first side panel by inserting the front edge of the panel into the lip at the front of the firebox. Then slide...
28 installer information 5056.412-e figure 41: burner tray log burner kit installation / removal air deflector installation / removal installation position the air deflector in the fireplace as seen in figure 40 and secure with two screws using a screwdriver. Removal remove the two screws seen in fi...
29 installer information 5056.412-e log set installation / removal installation 1. Position rear log against the back firebox as seen in figure 45. 2. Position front log just behind the front burner tube as seen in figure 46. 3. Position log 3 with the thin end of the log resting on top of the right...
30 installer information 5056.412-e rustic log set installation / removal figure 50: log set figure 51: rear log installation figure 53: side log installation figure 55: complete log set figure 54: decorative log installation figure 52: front log installation installation 1. Position rear logs #1 an...
31 installer information 5056.412-e glass burner kit installation / removal air deflector installation / removal installation position the air deflector in the fireplace as seen in figure 56 and secure with two screws using a screwdriver. Removal remove the two screws seen in figure 56 using a screw...
32 installer information 5056.412-e the esteem and estate fireplaces both come with an adjustable damper that can limit the flow of intake air. This damper is located behind the air deflector at the rear of the inner firebox. Sometimes on installations that involve vertical venting configurations ov...
33 installer information 5056.412-e replacement parts description order number 1. Esteem screen.............................................................. Gbwy.Scrna 2. Estate screen ............................................................... Gbnt.Scrna 3. Propane conversion kit.................
34 installer information 5056.412-e caution: label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. Wiring diagram figure 61: wiring diagram.
35 installer information 5056.412-e notes: __________________________________________________________________________________________________ __________________________________________________________________________________________________ ___________________________________________________________...
36 installer information 5056.412-e.
© 2015 copyright pacific energy fireplace products ltd reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. For technical support, please contact your retailer web site: www. Pacificenergy.Net 2975 allenby rd., duncan, b...