Installation a n d o p e r at i n g instructions 220514 -20 vista and classic-c 5055.3as models pacifi c vista vista classic series - c safety notice if this stove is not properly installed, a house fi re may result. For your safety, follow the installation instructions. Contact local building or fi...
Please save these instructions note: we strongly recommend that smoke detectors be installed. If smoke detectors have been previously installed, you may notice that they are operating more frequently. This may be due to curing of stove paint or fumes caused by accidentally leaving the fi re door ope...
220514-20 3 caution: - do not overtighten, tighten screws very carefully - do not clean glass when hot - do not use abrasive cleaners on glass 6. Do not store wood within heater installation clearances, or within the space required for fuel loading and ash removal. Keep the area around the heater cl...
4 220514-20 maintenance checks check the following parts for damage such as cracks, excessive corrosion, burned out sections and excessive warping: (see website for descriptions and more detail) weekly: - firebrick - visual, for cracking. - door gasket - sagging, placement, damage. Monthly - brick r...
220514-20 5 creosote formation and need for removal when wood is burned slowly, it produces tar and other organic vapours, which combine with expelled moisture to form creosote. The creosote vapours condense in the relatively cool chimney fl ue of a slow burning fi re. As a result, creosote residue ...
705mm 156mm 632mm 145mm 403mm 499mm 145mm 403mm 510mm 156mm 610mm 705mm 403mm 145mm 510mm 610mm 159mm 705mm 6 220514-20 assembly crate removal: 1) carefully remove wood top and supports. 2) remove plastic cover. 3) using a 7/16" wrench, remove lag bolts that secure stove body to bottom pallet. 4) pl...
220514-20 7 installation warning: under no circumstances is this heater to be installed in a make- shift or "temporary" manner. It may be fi red only after the stove is installed properly. Do not attempt to connect this heater to any air distribution duct. Outside combustion air or fresh air into th...
8 220514-20 527mm 660mm 200mm 706mm 350mm 375mm 527mm 660mm 250mm 776mm 250mm 200mm 250mm 350mm single wall connector minimum clearance to combustibles fig. #2 [300mm] [781mm] [723mm] [200mm] [200mm] fig. #3 non-combustible floor protector floor protector the stove may be installed on a combustible ...
220514-20 9 chimney and connector warning: install chimney and all components of chimney system according to chimney manufacturer’s instructions. Connect to a listed chimney complying with the requirements of as/nzs2918/2001 and a chimney suitable for use with solid fuel that is lined and in good co...
C b a 10 220514-20 pacifi c vista and vista classic firebrick installation instructions this package contains 12 full-size fi rebricks, as well as 2 various cut-size bricks. If your heater came with an ash cleanout system, or an optional one is being in- stalled, discard one full-size brick. With th...
220514-20 11 combustion air intake or combustion air can be supplied to the stove in one of two ways. Consult your local building code or installation code for solid-fuel-burning appliances and equipment before proceeding. 1. Outside air supply - (necessary for mobile home installation, optional for...
12 220514-20 operation caution: never use gasoline, gasoline type lantern fuel, kero- sene, charcoal lighter fl uid or similar liquids to start or “freshen up” a fi re in this heater. Keep all such liquids well away from the heater while it is in use. Caution: hot while in operation. Keep children, ...
220514-20 13 warning: always keep loading door closed when burning. This heater is not designed for open door burning. Warning: no alteration or modifi cation of the com- bustion air control assembly is permitted. Any tamper- ing will void warranty and could be very hazardous. Warning: do not use gr...
14 220514-20 troubleshooting problem cause cure glass is dirty 1. Wood is wet - use dry wood 2. Turning down air control - do not turn down until: too soon a) there is a good bed of coals b) the wood is charred 3. Draft too low - improper chimney height and/ or diameter - chimney plugged or restrict...
220514-20 15 replacement parts - pacifi c vista figure #5 (when ordering, include part number with description) item description part no. Item description part no. 1......... Side shield, left or right ..................... Vist.2201 2......... Top defl ector .....................................Vis...
17 23 24 16 220514-20 replacement parts - vista classic figure #6 (when ordering, include part number with description) item description part no. Item description part no. 1...... Vista classic side shield, l/r ............ Visc.2251 2...... Vista classic top ................................ Visc.22...
220514-20 17 operating tips 1. Always use dry, seasoned fi rewood, up to 457mmlong. Load wood endwise, a mixture of large and small pieces, on top of a good ash base (25mm minimum). 2. Operate on a medium to high setting, for up to 1 hour from cold start. After the initial warm up period, refuel and...
18 220514-20
220514-20 19 compliance plate 300114 5050.41as model: alderlea t4, vista, vista classic series: c type: freestanding made in canada maximum average heat output burning hardwood - 7.2 kw overall average efficiency burning hardwood - 67% when tested in accordance with as/nzs 4012 distributed by: pivot...
20 220514-20 printed in canada pacific energy fireplace products ltd. 2975 allenby rd., duncan, bc v9l 6v8 phone: 250-748-1184 web site: www.Pacifi cenergy.Net.
