Pacific Hydrostar 212cc Owner's Manual & Safety Instructions - Assembly
Page 9
For technical questions, please call 1-800-520-0882.
ITEM 69734 / 69737
assembly
1. Operation of this equipment may create sparks
that can start fires around dry vegetation. A spark
arrestor may be required. The operator should
contact local fire agencies for laws or regulations
relating to fire prevention requirements.
2.
Brass Pump
Plug (14A)
Aluminum Pump
Breather Plug
(59A)
Dipstick (60A)
Figure a
Replace the Brass Pump Plug (14A) with the
aluminum Pump Breather Plug (59A) and Dipstick
(60A) before first use. The Pump Breather Plug
must be used whenever the pressure washer is
used. The Brass Pump Plug (without the breather
hole) should be used for transporting only.
3. Attach the Handle (14) onto the Frame (17)
with the Handle Bolts (15) and Nuts (16).
4.
Outlet
Connector
(35A)
Water Inlet
Connection
Detergent Inlet
Connection
(26A)
Pressure Regulator Knob (44A)
Figure 2
Attach the Hose (18) to the Outlet Connector
(35A) on the unit (See Figure 2).
5. Pull the Collar at the end of the hose back
and attach the Gun (19) to the hose.
6. Screw the Wand (20) onto the Gun (19)
and secure with the grommet.
7. Choose the right Nozzle (5) for the job. Pull back
the quick connect collar and push the Nozzle
onto the end of the Wand. Make sure the quick
connect collar locks the Nozzle in place.
• Black Nozzle -
Low Pressure
Used with pressure washer detergent.
• White Nozzle -
Wide Spray
Used to clean very large areas.
• Green Nozzle -
Medium Spray
Used to clean large areas.
• Yellow Nozzle -
Narrow Spray
Used to clean small areas.
• Red Nozzle -
Pencil Spray
Intense stream. Only use on hard surfaces such
as concrete or metal. Can damage wood.
8. Connect the water supply to the Water Inlet
Connection on the Water Inlet Body (42A).
The water source must be able to provide a
minimum of five gallons of clean, cold water per
minuteat20PSI.Onlyusea5/8″innerdiameter
(or larger) hose that is rated to meet this capacity.
if using detergent:
Read detergent directions. Connect one end of
the Detergent Inlet Hose (8) to the Detergent Inlet
Connection, and the other end into the container
holding the detergent. Only use detergents specified
for use with Pressure Washers. The Pressure
Washer will draw one gallon of detergent for
every seven gallons of water. Only use the Black
(low pressure) Nozzle when spraying detergents.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup