Pacific Hydrostar 97552 Set Up, Operating, And Servicing Instructions - Danger
Page 13
SKU 97552
For technical questions, please call 1-800-444-3353.
break-in Period
Breaking-in the engine will help to
1.
ensure proper equipment and engine
operation.
The operational break-in period will
2.
last about 3 hours of use. During this
period:
Do not apply a heavy load to the
•
equipment.
Do not operate the engine at its
•
maximum speed.
The maintenance break-in period will
3.
last about 20 hours of use. After this
period:
Change the engine oil.
•
Under normal operating conditions
subsequent maintenance follows
the schedule explained in the
MAINTENANCE AND SERVICING
section.
equipment Operation
Choose the Nozzle that best meets
1.
the needs of the job. Only use the
Nozzles on surfaces capable of
withstanding the force of the spray
Red Nozzle - direct spray stream.
•
This Nozzle should only be used
on hard surfaces such as concrete
or metal. This Nozzle can damage
wood.
Yellow Nozzle - 15° spray range.
•
This Nozzle is used to clean small
areas.
Green Nozzle - 25° spray range.
•
This Nozzle can be used to clean
larger areas.
White Nozzle - 40° spray range.
•
This Nozzle can be used to clean
very large areas.
Black Nozzle - This Nozzle is used
•
with pressure washer detergent.
never direct spray
from the pressure
washer at a person or an
animal. the water stream
could cause serious injury.
Only use the
pressure washer
on surfaces capable of
withstanding the force of the
spray.
Only use the black
nozzle when using
pressure washer detergent.
the power of the other
nozzles will propel mist back
at the operator and can imbed
the detergent into the surface.
Pull back the quick connect collar and
2.
push the Nozzle onto the end of the
Wand. Make sure the quick connect
collar locks the Nozzle in place.
Turn the water supply on and hold
3.
down the Trigger to start the stream.
Be aware that when it is first started,
the gun will kick.
It is best to start at a low pressure
4.
setting, and adjust the pressure
upwards. Test spray the edge of
the surface to be cleaned first to
make sure that the stream is not
too strong for the surface. If the
stream damages the surface turn the
Pressure Regulator Knob towards the
“
—” to reduce the pressure. Moving
further away from the surface being
cleaned will also reduce the pressure
being applied to the surface. If the
stream is still too strong. Turn the
water supply off, turn the engine off,