Pacific Hydrostar 98439 Set Up, Operating, And Servicing Instructions - Operating Instructions
Page 9
SKU 98439
For technical questions, please call 1-800-444-3353.
assembly
Attach the Hose Hook (31) onto the
1.
right side of the Handle using Bolts
(19), Locknuts (20), and Washers
(21).
Attach the Gun Hook (30) onto the
2.
left side of the Handle using Bolts
(19), Locknuts (20), and Washers
(21).
Attach the Hose (2) to the Hose Con-
3.
nection on the unit. (See picture on
the next page.)
Screw the Gun (22) onto the hose.
4.
Connect the water supply to the
5.
Water Inlet Connection. The water
source must be able to provide a
minimum of four gallons of clean,
cold water per minute at 30 PSI.
Only use a hose that is rated to meet
this capacity and pressure level.
Direct the hose on the Bleeder Valve
6.
away from anything that might be
harmed or damaged by a discharge
of hot water.
if using detergents:
Read the detergent’s directions.
7.
Connect one end of the Detergent
Hose (17) to the Detergent Inlet Con-
nection, and place the other end into
the container holding the detergent.
Only use detergents specified for use
with Pressure Washers. Only use the
equipment in the low pressure setting
by pulling outwards the nozzle when
spraying detergents.
Hose
connection
water inlet
connection
detergent inlet
connection
bleeder
valve
OPerating instructiOns
read the entire iMPOrtant
saFetY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
starting the engine
inspect engine and equipment
looking for damaged, loose,
and missing parts before
set up and starting. if any
problems are found, do not use
equipment until fixed properly.
checking engine Oil Level
cautiOn! Your Warranty is VOID if the
engine’s crankcase is not properly
filled with oil before each use. Before
each use, check the oil level. Do not
run the engine with low or no engine