Pacific Hydrostar 98444 Set Up, Operating, And Servicing Instructions - Danger
Page 12
SKU 98444
For technical questions, please call 1-800-444-3353.
The operational break-in period will
2.
last about 3 hours of use. During this
period:
Do not apply a heavy load to the
•
equipment.
Do not operate the engine at its
•
maximum speed.
The maintenance break-in period will
3.
last about 20 hours of use. After this
period:
Change the engine oil.
•
Under normal operating conditions
subsequent maintenance follows the
schedule explained in the MAINTE-
NANCE AND SERVICING section.
equipment Operation
Choose the Nozzle that best meets
1.
the needs of the job. Only use the
Nozzles on surfaces capable of with-
standing the force of the spray
Red Nozzle - direct spray stream.
•
This Nozzle should only be used
on hard surfaces such as concrete
or metal. This Nozzle can damage
wood.
Yellow Nozzle - This Nozzle is used
•
to clean small areas.
White Nozzle - This Nozzle can be
•
used to clean large areas.
Black Nozzle - This Nozzle is used
•
with pressure washer detergents.
never direct spray
from the pressure
washer at a person or an
animal. the water stream
could cause serious injury.
Only use the
pressure washer
on surfaces capable of
withstanding the force of the
spray.
Only use the black
nozzle when using
pressure washer detergents.
the power of the other
nozzles will propel mist back
at the operator and can imbed
the detergent into the surface.
Pull back the quick connect collar and
2.
push the Nozzle onto the end of the
Gun. Make sure the quick connect
collar locks the Nozzle in place.
Check to make sure the Engine has
3.
the proper level of oil. Also, make
sure the Fuel Tank is filled with un-
leaded gasoline.
Turn the water supply on. To allow
4.
air to escape from the High Pressure
Hose, squeeze the Trigger until there
is a steady stream of water coming
from the Nozzle.
Start the Engine by following the En-
5.
gine Operating Section.
Hold down the Trigger to start the
6.
stream. Be aware that when it is first
started, the gun will kick.
Test spray the edge of the surface
7.
to be cleaned first to make sure that
the stream is not too strong for the
surface. If the stream damages
the surface move further away from
the surface being cleaned will also
reduce the pressure being applied
to the surface. If the stream is still
too strong; turn the engine off, turn
the water supply off, discharge the
excess pressure from the gun by