Pacific International Fans EM-E Installation Manual - 1300 360 280

IMPORTANT INFORMATION 

ELECTRICIANS MUST READ PRIOR TO INSTALLATION 

1.  Distributor and installer details and purchase receipts are essential for on-site warranty claims 

and must be presented to repair personnel, make sure you record your details in the Fan Owner 

Warranty and Operations Manual. 

2.   Fans and fixed wiring products must only be installed by persons who are appropriately licensed 

by the applicable State regulatory body. Therefore, to protect our repair personnel, on-site  

warranty claims will not be accepted if products have been installed by unlicensed persons.   

3.

Damage caused by incorrect installation, force-majeure, electrical surges, lightning, power grid 

fluctuations,  water or by connection to alternative power supply sources (such as solar inverters, 

etc.) is not eligible for warranty repair. 

4.

Blades must be replaced only as a complete set. Blades are supplied only as a pre-balanced set 

and the replacement of individual blades may void the warranty by causing mechanical  

damage to the motor, excessive noise or premature wear. 

5.

When products are installed in a location requiring special access equipment (such as  

  scaffolding or scissor lifts, etc) the cost of providing, installing and operating special access 

equipment must be borne by the site owner.  

For safety, and to protect your customers warranty, the following must be taken into  

account when installing and operating the product (s): 

IF THERE ARE ANY PROBLEMS WITH THE PRODUCT AT TIME OF 

INSTALLATION THE INSTALLER MUST CONTACT THE WARRANTY 

HOT LINE NUMBER 

1300 360 280

. 

BEFORE LEAVING THE JOB 

SITE.  PLEASE DO NOT REMOVE THE FAN FROM THE CEILING  

ONCE INSTALLED UNLESS INSTRUCTED TO DO SO. 

(a)

DO NOT USE SOLID-STATE WALL CONTROLLERS. Neither leading nor lagging edge 

controllers will give satisfactory performance. Wall controls must only be types approved 

for use by Pacific International Ceiling Fans.   

(b)

The fan, light and bracket must be earthed. 

(c)

Fan and light must be run from the same phase and preferably the same final circuit. 

(d)

Mounting bracket must be firmly screwed to a solid structure such as a concrete ceiling, 

steel structure or timber framing. If additional bracing is added it must be firmly secured to 

the rafters and not left  floating on the ceiling. Special mounts, such as T-hooks, are  

available for certain types of installation. 

(e)

After installation, fan blades must be at least 2.1 m (7 feet) above floor level. 

(f)

The use of these products by children and the infirm must be under supervision. 

Electrician Installation Manual 

   EM-E Ceiling Fan 

2