Pacific My Vac Operating Instructions Manual

Manual is about: Commercial Upright Vacuum Cleaner

Summary of My Vac

  • Page 1

    My vac ™ commercial upright vacuum cleaner review this manual before operating cleaner operating instructions english ➜ pp.1-13 espaÑol ➜ pág 14-20 franÇais ➜ p. 21-27 index assembling cleaner ..........................2-5 cleaner descriptions ............................6 how to use cleaning tools....

  • Page 2: Assembling Cleaner

    Place upper (b) and lower (c) handle sections on a flat sur- face with cord hooks (a) on top. With hands on sides of han- dle sections, push handle sections together firmly until they “click” into place. *do not press against the rod (d) extending from the lower handle. If the rod breaks or bends, t...

  • Page 3

    Up 3 d step 2 attach cord note: the small red tab (e) above the on/off switch (f) is for shipping purposes only and may fall off during assembly. If it does not fall off, the tab will be removed during the final steps of assembly. Turn handle over. Insert large rectangular end of cord into pocket in...

  • Page 4

    Break off red tab (e) above on/off switch (f) by pushing down on tab. Discard tab. Note: if tab has come off during assembly, make sure switch is in the off position (down) before plugging cord into an electrical outlet. Hold filter bag collar (u) as shown. Align opening in filter bag with dirt tube...

  • Page 5

    Place furniture nozzle (bb) on lip on lower part of rack and snap into place. Position dusting brush (aa) into rack as shown. With smaller end toward bottom, snap wand (z) into clips on rack. 5 slide rack down handle until upper hooks (x) snap into slots (y) on han- dle. Place round end of hose over...

  • Page 6: How to Use

    The assembled cleaner will look like the drawing. 1. Handle 2. Cord hooks: wrap cord around hooks for storage. The top hook can be rotated right or left for easy cord release. 3. Bag cap 4. On/off switch: located on side of handle 5. Outer bag 6. Stair cleaning handle: located on lower edge of bag. ...

  • Page 7

    For maximum cleaning perfor- mance, the following carpet height settings are recommended. Cleaners with two settings: • setting 1 (a): for bare floors and all carpet types. • setting 2 (b): if easier pushing effort is desired while maintaining good cleaning performance. Cleaners with four settings: ...

  • Page 8

    8 tool set includes a hose, wand, crevice tool, furniture nozzle and dusting brush. Attach hose to cleaner turn cleaner off before attaching or removing hose. With cleaner handle in upright posi- tion, open hose door and insert hose connector until locked in posi- tion. Suction will automatically be...

  • Page 9

    9 how to replace disconnect cleaner from electrical outlet. To change filter bag, unzip outer bag, grasp sides of filter bag collar (a) and pull collar from tube. Note: do not clean out old filter bag and reuse. Discard used filter bag. Clearing blockages to check for obstructions, first turn cleane...

  • Page 10

    10 place the three tabs on bottom plate into slots in front of cleaner body. Snap bottom plate into place over agitator. Slip agitator through new belt (with lettering toward outside of clean- er) and position belt in belt guide (d). Push end of belt into opening in cleaner body. Reposition agitator...

  • Page 11

    Replace hood and nozzle control knob. Stretch new belt onto motor pulley (g). Extra effort may be required to stretch belt onto pulley. Turn agitator, making sure belt is not pinched between agitator and cleaner body. The belt must rotate freely inside the belt guide. If the agitator does not turn, ...

  • Page 12: Lubrication

    Servicing of double- insulated appliances this vacuum cleaner is double insulat- ed. In a double insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulat- ed appliance, nor should a means for grounding be added. Servicing a ...

  • Page 13

    13.