Pacific Steamex TRIUMPH 430 Operating & Maintenance Instructions

Manual is about: self-contained

Summary of TRIUMPH 430

  • Page 1

    Operating & maintenance introduction instructions read this book this operator’s book has important information for the use and safe operation of this machine. Read this book care- fully before starting the machine. Keep this book and tell all operators to read the book. If you do not follow the ins...

  • Page 2: Introduction

    Introduction the pacific steamex triumph 430 is a fully self-contained, portable carpet extractor system. The triumph 430 has a 60 psi solution pump and a two (2) jet spraying system to apply solution to the carpet. A rotating brush is driven by a cogged belt system at approximately 1000 rpm’s. This...

  • Page 3

    When using an electrical appliance, basic precautions should always be followed, including the following: read all instructions before using this machine warning : to reduce the risk of fire, electric shock, or injury: 1. You must have training in the operation of this machine before using it. 2. Ma...

  • Page 4: Operating Procedures

    Operating procedures warning! For the safe operation of this machine follow the instructions given in this booklet and the train- ing given by your supervisor. Failure to do so can result in personal injury and/or damage to machine and prop- erty! Do not operate machine in an explosive environment! ...

  • Page 5: Servicing

    8. Release the red button approximately 6 inches before completing each pass. The spray jets are located be- hind the vacuum head making it necessary to pull the machine a few inches further to pick up the last amount of solution dispensed onto the carpet. 9. Tilt the machine back on the rear wheels...

  • Page 6

    An authorized service center should perform the following procedures: drive belt adjustment and/or replacement: the cogged belt drive system rarely requires tightening. If the belt becomes loose from wear, it is time to replace it. Follow this procedure: remove acorn nut and thru-bolt from brush cha...

  • Page 7

    7.

  • Page 8: Triumph 430

    Triumph 430 drawing 1 8 03/01.

  • Page 9: Triumph 430

    Triumph 430 drawing 1 9 item pt # description qty. 1 204170 hose - vac head, 17 ″ 1 2 3698 cuff 3 3 204171 hose - vac short, 6 ″ 1 4 d161c decal - warning add defoamer 1 5 202770 dome 1 6 203470 gasket – dome 1 7 202472 recovery container 1 8 208671 liner 1 9 w172d screw 10-24 x 3/8 php 10 10 920618...

  • Page 10: Triumph 430

    Triumph 430 drawing 2 07/01.

  • Page 11: Triumph 430

    Triumph 430 drawing 2 11 07/01 item part no. Description qty. Item part no. Description qty. 1 204182 hose – 12” reinforced 1 32 w353d screw 1/4-20 x 1/2" fhp 2 2 203359 fitting – 3/8 hose barb 3 33 980032 washer 2 3 203302 quick connect – ¼ male 1 34 a13438 guard - belt 1 4 203308 quick connect – ¼...

  • Page 12

    Warranty policy pacific steamex inc. Limited warranty the pacific steamex inc. Triumph 430 carpet extractor has been manufactured, tested and inspected in accordance with specific engineering requirements and is warranted to be free from defects in workmanship and materials as follows: five (5) year...