Tsunami / high flow extractor operations & maintenance operations & maintenance operations & maintenance operations & maintenance operations & maintenance pfm/mem/1102 pacific floor machine co..
Tsunami carpet extractor setup and operations tsunami carpet extractor setup and operations tsunami carpet extractor setup and operations tsunami carpet extractor setup and operations tsunami carpet extractor setup and operations setting the chemical dilution ratio on the mac setting the chemical di...
Mac mac mac mac machine operations hine operations hine operations hine operations hine operations read and understand the operators manual that came with the machine. If this manual is not on hand it may be ordered from your local pacific dealer or by calling pacific directly at 800-968-1332 and sp...
Assemb assemb assemb assemb assemble the needed le the needed le the needed le the needed le the needed t t t t tools ools ools ools ools tsunami with hoses and chemicals tsunami with hoses and chemicals tsunami with hoses and chemicals tsunami with hoses and chemicals tsunami with hoses and chemica...
V v v v vacuum the carpet area acuum the carpet area acuum the carpet area acuum the carpet area acuum the carpet area genius 14, a good 2 motor upright vacuum remove the aerator from the sink and install a matching adaptor from the hardware kit sup- plied with the machine. Prepair the sink prepair ...
Attac attac attac attac attach the hose assemb h the hose assemb h the hose assemb h the hose assemb h the hose assembllllly y y y y attach the gray hose to the faucet and check for leaks. Secure clear drain hose in sink, floor drain or commode. Plug electrical cable into grounded outlet. These valv...
Pretreat as needed and begin cleaning pretreat as needed and begin cleaning pretreat as needed and begin cleaning pretreat as needed and begin cleaning pretreat as needed and begin cleaning position the machine for the first cleaning pass. Turn the vacuum switch on. Depress the intermittent spray bu...
Mac mac mac mac machine maintenance hine maintenance hine maintenance hine maintenance hine maintenance remove the see through cover on the front of the machine to access the filters and the float switch. The vacuum filter screen should be cleaned after each job. Wipe the screen clean on a regular b...
The pump filter screens can be removed from the machine and disassembled for a complete cleaning. The pump float switch should be removed periodi- cally and given a thorough cleaning and inspection. The see through channel cover should be removed for cleaning on a regular basis. Use a wet pick up va...
Remove the impeller and wipe clean the running surfaces inside the pump hous- ing. Coat the new impeller and running surfaces with a bit of vegetable oil. The rubber, paddle wheel, impeller is a wear item and will need to be replaced periodically. This pump is located in the right rear of the machin...
After inspection, install the new coated impeller. Make sure the impeller fits tightly on the motor shaft and is well seated in the housing. Reinstall the machine cowling and secure with the 2 mounting screws. Do an assurance test on the pump before sending the unit back into the service. Check the ...
Tr tr tr tr trouble shoo ouble shoo ouble shoo ouble shoo ouble shooting char ting char ting char ting char ting chart t t t t 1. Recovery tank will not drain 2. No water at machine 3. Vac motor rpms very low 4. Vac motor will not turn on 5. No chemical injection with prespray 6. Back filling of pre...
