Packard Bell Compaesseo 300 Disassembly Manual

Other manuals for Compaesseo 300: User Manual
Manual is about: DIVX

Summary of Compaesseo 300

  • Page 1

    Packard bell compasseo 300 & 400 disassembly manual.

  • Page 2: Table of Contents

    Table of contents overview ................................................................................................................................................ 1 disassembly instructions.........................................................................................................

  • Page 3: Overview

    1 overview this document contains step-by-step disassembly instructions for the packard bell compasseo. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Packard bell reserves the right to make changes to the product without notice. Disas...

  • Page 4: Opening The Case

    2 opening the case to open the case, do as follows: 1. Remove the two screws at the bottom of the compasseo. 2. Remove the four rubbers from the holes at the back. 3. Then remove the four screws from the same holes. 4. Lift and take away the rear cover. The speaker remove the speaker by following th...

  • Page 5: The Antenna

    3 3. Remove the two screws that secure the speaker to the antenna holder (see the circles in fig. 3). The antenna perform the following steps to remove the antenna: 1. Disconnect the gps antenna from the mainboard (see the circle to your right in fig. 4). 2. Slide the gps antenna upwards out of its ...

  • Page 6: The Gps Module

    4 2. Lift the antenna holder from the mainboard. Fig. 5 the screw that keeps the antenna holder in place. The gps module follow these steps to remove the gps module: 1. Disconnect the gps cable from the mainboard (see the square in fig. 6). 2. Remove the two screws of the gps module (see the circles...

  • Page 7: The Mainboard

    5 the mainboard follow the steps below to remove the mainboard: 1. Unlock the flat cable lock upwards (see the square in fig. 7). 2. Take the flat cable out of the connector. 3. Lift the mainboard from the casing. The lcd panel follow the steps below to remove the lcd panel: 1. Slightly bend the two...

  • Page 8: Notice

    6 notice the information in this document is subject to change without notice. This document contains information protected by copyright. No part of this document may be photocopied or reproduced in any form or by any means without prior written consent from packard bell b.V. Packard bell b.V. Shall...