Summary of EasyNote MT
Page 1
Packard bell easynote mt disassembly manual.
Page 2: Table of Contents
11111 packard bell easynote mt disassembly manual 1 table of contents about this guide........................................................................................................................................ 2 for more information .........................................................
Page 3: About This Guide
Packard bell easynote mt disassembly manual 2 about this guide this guide contains systematic disassembly instructions for the packard bell easynote mt. The instructions are illustrated where necessary with images of the part that is being disassembled. Packard bell b.V. Reserves the right to make c...
Page 4: Hazardous Voltage
Packard bell easynote mt disassembly manual 3 hazardous voltage there is hazardous voltage present inside the notebook when it is connected to an ac supply, even when the notebook’s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk of injury, contact an au...
Page 5: Battery
44444 packard bell easynote mt disassembly manual 4 battery perform the following steps to remove the battery: 1. Make sure the power is off. 2. Turn the notebook upside down. Note: use an anti-static mat or something soft like a piece of cloth underneath the notebook to prevent damage to the exteri...
Page 6: Memory
55555 packard bell easynote mt disassembly manual 5 2. Lift the cover upwards from the right. There are two tabs holding the cover in place on the left. Raise the cover until you can remove it from the casing (see fig. 2 ). 3. Pull the plastic tab on the hard disk drives towards the left to disconne...
Page 7: Optical Disk Drive
66666 packard bell easynote mt disassembly manual 6 1. Remove the two screws securing the memory compartment cover. Fig. 5 removing memory compartment cover. 2. Lift the cover upwards from the right. There are three tabs holding the cover in place on the left. Raise the cover until you can remove it...
Page 8
77777 packard bell easynote mt disassembly manual 7 1. Remove the screw securing the optical disk drive. Fig. 7 location screw securing optical disk drive. 2. Use the emergency eject hole to open the optical disk drive. 3. Pull the tray and take out the optical disk drive from the drive bay (see fig...
Page 9: Keyboard
88888 packard bell easynote mt disassembly manual 8 5. Insert the flat screwdriver into the notch at the underside of the tray to release the tray bezel lock. Fig. 9 location tray bezel lock underside. 6. Insert the small flat screwdriver into the notch at the side of the tray to release the side lo...
Page 10: Keyboard Cover
99999 packard bell easynote mt disassembly manual 9 2. Release the keyboard by prying it up along the top side of the keyboard. There are five tabs holding the keyboard in place on the front, particularly at the following keys: , , , and . Fig. 11 removing keyboard. 3. Tilt the keyboard gently forwa...
Page 11: Top Cover
1010101010 packard bell easynote mt disassembly manual 10 1. Remove the nine screws securing the keyboard cover. Note that four screws are located in the battery compartment. Fig. 13 location keyboard cover screws. 2. Turn the notebook over so the top is facing up and open the lcd completely. 3. Rel...
Page 12
1111111111 packard bell easynote mt disassembly manual 11 4. Carefully disconnect the two wifi antenna cables fig. 15 location of wifi antenna cables. Note: there are two wifi antenna cables connected to the wireless lan adapter. The black wifi antenna cable is connected to main (1) connector and th...
Page 13: Lcd Assembly
1212121212 packard bell easynote mt disassembly manual 12 9. Remove the eight screws securing the top cover. Fig. 17 location of top cover screws. 10. Turn the notebook upside down and remove the top cover. Lcd assembly to disassemble the lcd assembly, first remove the top cover (see top cover on pa...
Page 14: Speakers
1313131313 packard bell easynote mt disassembly manual 13 3. Remove the screws (three in each side) securing the hinges. Fig. 19 location lcd hinge screws. Note: in fig. 19 , some of the screws are partly covered by adhesive tape and/or cables. 4. Lift out the lcd assembly. Speakers to remove the sp...
Page 15: Bluetooth (Optional)
1414141414 packard bell easynote mt disassembly manual 14 3. Disconnect the speaker cables from the header on the main board. Fig. 21 location of speaker cable header on the main board. Note: the left and right speaker assembly share the same header on the main board. 4. Remove the speakers assembly...
Page 16: Usb Board
1515151515 packard bell easynote mt disassembly manual 15 usb board to remove the usb board, first remove the top cover (see top cover on page 10), and then do the following: 1. Release the white clip securing the usb board cable and disconnect it from the header on the main board. Fig. 23 releasing...
Page 17
1616161616 packard bell easynote mt disassembly manual 16 1. Remove the screws securing the brackets that hold the left and right speaker assembly. Fig. 25 location of speaker brackets screws. 2. Release the white clip securing the audio board cable and disconnect it from the header on the main boar...
Page 18: Cmos Battery
1717171717 packard bell easynote mt disassembly manual 17 6. Remove two screws marked with a white triangle securing the main board. Fig. 27 location of main board screws. 7. Remove two screws from the bracket holding the main board. Fig. 28 location of main board bracket screws. 8. Lift the main bo...
Page 19: Wireless Lan Adapter
1818181818 packard bell easynote mt disassembly manual 18 1. Disconnect the cmos battery cable from the header on the main board. Fig. 29 location cmos battery. 2. The cmos battery has been glued onto the main board; pull it loose gently (see fig. 29 ). Wireless lan adapter to remove the wireless la...
Page 20: Cpu and Heat Sink
1919191919 packard bell easynote mt disassembly manual 19 1. Turn the main board upside down. 2. Remove the two screws securing the tv tuner; the card will eject upwards. Fig. 31 location of tv tuner screws. 3. Take out the tv tuner card from the socket. Note: the easynote mt can have a tv tuner car...
Page 21
2020202020 packard bell easynote mt disassembly manual 20 2. Disconnect the fan cable from the header on the main board. Fig. 32 location of chipset heat sink screws. 3. Remove the three screws securing the heat sink in designated order (see fig. 32 ). 4. Remove the fan/chipset heat sink. 5. Remove ...
Page 22: I/o And Hdmi Board
2121212121 packard bell easynote mt disassembly manual 21 7. Turn the screw in the cpu into the unlock position to release the cpu. Fig. 34 location of screw securing cpu. 8. Carefully take out the cpu from the socket. I/o and hdmi board to remove the i/o and hdmi board, first remove the main board ...
Page 23: Audio Board
2222222222 packard bell easynote mt disassembly manual 22 audio board to remove the audio board, first remove the main board (see main board on page 15), and then do the following: 1. Remove the screw securing the board. Fig. 36 releasing the audio board. Note: fig. 36 shows the audio cable still co...
Page 24: Tv Antenna (Optional)
2323232323 packard bell easynote mt disassembly manual 23 2. Take out the subwoofer. Tv antenna (optional) to remove the optional tv antenna cable, first remove the main board (see main board on page 15), and then perform the following steps: 1. Remove the screw securing the tv antenna connector. Fi...
Page 25: Button Board
2424242424 packard bell easynote mt disassembly manual 24 2. Remove the four screws securing the touchpad bracket to the top cover (see fig. 41 ). 3. Remove the touchpad module. Note: the described procedure applies only to the touchpad module, which holds the touchpad buttons; the touchpad surface ...
Page 26: Inverter Board
2525252525 packard bell easynote mt disassembly manual 25 note: in fig. 41 , the screws in each of the lower corner are covered by cables. 3. Carefully pry open the lcd bezel; it has been clicked into place. Inverter board to remove the inverter board, first remove the lcd bezel (see lcd bezel on pa...
Page 27: Webcam/microphone
2626262626 packard bell easynote mt disassembly manual 26 3. Remove the ten screws securing the side brackets (five screws on each side) and remove the brackets (see fig. 43 ). 4. Separate the lcd panel from the back cover. 5. Disconnect the lcd cable. Fig. 44 location of lcd cable connector. 6. Rem...
Page 28: Notice
2727272727 packard bell easynote mt disassembly manual 27 notice the information in this guide is subject to change without notice. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent...