Packard Bell EasyNote S Disassembly Manual - Removing The Keyboard
Packard Bell EasyNote S Disassembly Manual
7
2. Fold the LCD completely backwards.
3. Push up the hinge/keyboard cover, which is also the keyboard cover. Use moderate force
and/or use a screwdriver to lift the part on one side.
4. Fold back the hinge/keyboard cover and disconnect the flat cable by pulling up the brown clip
to release the flat cable.
Fig. 8 Button panel flat cable connection.
5. Remove the disconnected button panel.
Removing the Keyboard
To remove the keyboard, first remove the button panel (see
Removing the Button Panel
), then perform
the following steps:
1. Pull the keyboard up from the top side and gently lift the keyboard away.
2. Disconnect the flat cable from the main board (pull up the white holder to release the flat
cable).
3. Take out the keyboard.
Note
If you only need to replace the keyboard, you do not need to disconnect the flat cable of the
button panel.
Removing the Heat Shield
To remove the heat shield, first remove the button panel (see
Removing the Button Panel
) and remove
the keyboard (see
Removing the Keyboard
), then perform the following steps:
1. Remove the 8 screws retaining the heat shield.